Sharp LC-32LE700UN Service Manual page 35

3. Entering and exiting the adjustment process mode
1) Before entering the adjustment process mode, the AV position RESET in the video adjustment menu.
2) While holding down the "VOL (–)" and "INPUT" keys at a time, plug in the AC cord of the main unit to turn on the power.
The letter "<K>" appears on the screen.
3) Next, hold down the "VOL (–)" and "CH (
(The "VOL (–)" and "CH (
Multiple lines of blue characters appearing on the display indicate that the unit is now in the adjustment process mode.
When you fail to enter the adjustment process mode (the display is the same as normal startup), retry the procedure.
4) To exit the adjustment process mode after the adjustment is done, unplug the AC cord from the outlet to make a forced shutdown. (When the
power was turned off with the remote controller, once unplug the AC cord and plug it again. In this case, wait 10 seconds or so before plugging.)
CAUTION: Use due care in handling the information described here lest your users should know how to enter the adjustment process mode. If the
settings are tampered in this mode, unrecoverable system damage may result.
4. Remote controller key operation and description of display in adjustment process mode
1) Key operation
Remote controller key
CH ( / ) CH (
VOL (+/–) VOL (+/–)
Cursor (UP/DOWN)
Cursor (LEFT/RIGHT)
INPUT
ENTER
*Input mode is switched automatically when relevant adjustment is started so far as the necessary input signal is available.
2) Description of display
(1) Current page/
Total pages
1/40
MAIN Version
BOOT Version
Monitor/Monitor BOOT Version
LCD Con Version
LED TCON Version
EQ DATA CHECKSUM
TEMPERATURE
LAMP ERROR
MONITOR ERR CAUSE
NORMAL STANDBY CAUSE
ERROR STANDBY CAUSE
)" keys at a time.
)" keys should be pressed and held until the display appears.)
Main unit key
Moving an item (line) by one (UP/DOWN)
/ )
Changing a selected item setting (+1/ –1)
————— Turing a page (PREVIOUS/NEXT)
————— Changing a selected line setting (+10/ –10)
————— Input switching (toggle switching)
————— Executing a function
(2) Current selected input
(3) Current color system
INPUT5
1.09 (U 2009/07/07 1A)
HLNR 100
1.02/1.00
0900626000T0001
16
ROM
7B
0
0
0
1) 0
0H 0M
4) 0
0H 0M
Function
(5) LCD Panel size/Speaker type
(4) Destination
AUTO USA 40_UNDER
2) 0 3) 0
0H 0M 0H 0M
5) 0
0H 0M
5 – 4
LC-32/40/46/52LE700UN
(6) Adjustment
process menu
header
(7) Parameters