Power Source - Memorex Mi2031-BLK User Manual

AC CONNECTION
Insert the small end of the AC adapter into
the DC IN 15V jack (located on the rear of
the unit). Connect the other end to a wall
outlet having 120V AC, 60 Hz.
AC Adapter, DC 15V Z
NOTES:
• Remove both the DC plug and the AC-
IN plug to disconnect the AC adapter
when not in use.
• Only use the supplied AC adapter which has the following specs: DC 15V Z
REMOTE BATTERY INSTALLATION
Follow these precautions when using a battery in this device:
1. Warning–Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
2. Use only the size and type of battery specified.
3. Be sure to follow the correct polarity when installing the battery as
indicated next to the battery compartment. A reversed battery may
cause damage to the device.
4. If the device is not to be used for a long period of time, remove the
battery to prevent damage or injury from possible battery leakage.
5. Do not try to recharge a battery not intended to be recharged; it can
overheat and rupture. (Follow battery manufacturer's directions.)

POWER SOURCE

1.
Remove the Battery Compartment by
pressing in on the tab and then sliding the
compartment out.
2. Install a CR2025 battery, paying attention
to the polarity diagram in the Battery
Compartment (positive side up).
3. Replace the Battery Compartment.
BATTERY PRECAUTIONS
5
To DC 5V IN Jack