Memorex M12001 User Manual

Speaker system for ipod
Table of Contents

Advertisement

Available languages

Available languages

Advertisement

Table of Contents
loading

Summary of Contents for Memorex M12001

  • Page 2: Safety Precautions

    CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This Caution Marking and Rating Label are located at the bottom enclosure of the unit. DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the...
  • Page 3 INFORMATION: This equipment complies with Class B digital device regulations. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
  • Page 4: Location Of Controls

    1. LINE IN and DC IN 15V Z Jacks (Rear of Unit) (AC Adapter Part No. 295-05220-E000*) 2. Left Speaker (1 of 2) 3. iPod Compartment with Connector & Interchangeable Universal Docks 4. Left Speaker (2 of 2) 5. Power Button 6.
  • Page 5 REMOTE 1. Power Button 2. VOL - Button 3. Skip/Search o Button 4. Play/Pause (®p) Button 5. DIMMER Button 6. Remote Transmitter (Top of Unit) 7. VOL + Button 8. Skip/Search n Button 9. MUTE Button 10.SLEEP Button 11. Battery Compartment (Rear of Unit) Remote Control Part No.
  • Page 6: Power Source

    AC CONNECTION Insert the small end of the AC adapter into the DC IN 15V jack (located on the rear of the unit). Connect the other end to a wall outlet having 120V AC, 60 Hz. AC Adapter, DC 15V Z NOTES: •...
  • Page 7: Optional Connection

    REMOTE BATTERY INSTALLATION Follow these precautions when using batteries in this device: Warning–Danger of explosion if batteries are incorrectly replaced. Replace only with the same or equivalent type. Use only the size and type of batteries specified. Be sure to follow the correct polarity when installing the batteries as indicated next to the battery compartments.
  • Page 8 Locate the correct Universal Dock to use as shown on page 15. Insert the Universal Dock (A) into the iPod compartment (B) (as shown), making sure the tabs are facing front, and slip the tabs into place. Press the rear side of the Universal Dock until it is positioned inside the iPod compartment.
  • Page 9: Operation

    USING AN iPod WITH THIS UNIT With an iPod connected (see previous page), if this unit is not already on, turn this unit on by pressing the Power button on the remote (shown) or on the main unit; “iPod” will appear in the display. To play/pause the iPod: Press Play/Pause...
  • Page 10: Adjusting The Volume

    ADJUSTING THE VOLUME To adjust the main volume: Press the VOL + 1 and/or - 2 button on the remote (shown) or the VOL +/MIN and/or -/HR button on the main unit to increase and/or decrease the volume. To mute the main volume: Press the MUTE button 3 on the remote;...
  • Page 11 TO SET OR RESET THE ACTUAL TIME With the power off, press the TIME SET/Skip/Search o button; the time will blink. Press the TIME SET/Skip/Search o button (or wait approx. 15 seconds) and the time will be set. Within 15 seconds, press the VOL +/MIN button 1 to set the present minute and the VOL -/HR button 2 to set the present hour.
  • Page 12 TO SET OR RESET THE ALARM TIME With the power off, press the ALARM SET/Skip/Search button; the Alarm time will blink in the display. The volume setting will appear in the display. Select a desired maximum volume level (level 1 to 15) to wake to using the VOL +/MIN 1 and/or -/HR 2 button.
  • Page 13 If set to iPod, insert the iPod as shown on page 7. Select your desired track and then make sure both your iPod and this unit are turned off. When the alarm time is reached, this unit will start playback on the track that you selected and the tracks following it in the playlist.
  • Page 14 TO SHUT THE ALARM OFF If the alarm was set to BUZZER, press the Power button 1 or ALARM button 2 and the alarm will turn off and be set for the next day. To NOT set the alarm for the next day, press the ALARM button 2 repeatedly to select alarm off (no indicator in the display).
  • Page 15 SLEEP With the unit in the LINE IN or iPod mode, press the SLEEP button on the remote; "10" will appear in the display for a few seconds. Repeatedly press the SLEEP button to turn the SLEEP feature on (“SLEEP” will appear in the display) and select a SLEEP time, 20-60 minutes (i.e., "20"–turns off automatically after 20...
  • Page 16 iPod UNIVERSAL DOCKS Locate your iPod in the chart below and select the respective Universal Dock (the Universal Dock No. is engraved at the front of the Universal Docks as shown on the next page) to match with your iPod. Insert the corresponding Universal Dock and your iPod into the unit as described on page 7.
  • Page 17 OPERATION (CONTINUED) IMPORTANT! The Universal Dock No. is engraved at the front of the docks. Please refer to the illustration below for the location of the Universal Dock No.
  • Page 18: Troubleshooting Guide

    If you experience a problem with this unit, check the chart below before calling for service. SYMPTOM No sound from iPod. iPod not charging. Time reset to “12:00”. Alarm does not turn on. CAUSE Volume is set to minimum or is muted. Incorrectly connected.
  • Page 19: Specifications

    PLEASE KEEP ALL PACKAGING MATERIAL FOR AT LEAST 90 DAYS IN CASE YOU NEED TO RETURN THIS PRODUCT TO YOUR PLACE OF PURCHASE OR MEMOREX. FOR CONSUMER REPLACEABLE PART(S), SEE PART NUMBER(S) ON PAGES 3, 4 AND 15 AND THEN CONTACT FOX INTERNATIONAL AT 1-800-321-6993.
  • Page 20 Memcorp, Inc. Weston, FL Printed in Hong Kong Visit our website at www.memorexelectronics.com 201-05220-E010...
  • Page 21 Mi2001 User’s Guide Alarm Clock and Home ® Speaker System for iPod with Remote Control Before operating this product, please read these instructions completely.
  • Page 22: Medidas De Seguridad

    ADVERTENCIA: Para reducir el riesgo de descargas eléctricas no abra la cubierta o tapa posterior. Allí no hay partes que el usuario pueda reparar. Lleve su unidad a un Centro de Servicio Autorizado. (Esta etiqueta con marca de alerta y clasificación se encuentra en el gabinete inferior de la unidad.) ADVERTENCIA:La figura del rayo con punta de flecha dentro de un triángulo está...
  • Page 23 INFORMACIÓN: Este equipo cumple con los reglamentos de un aparato digital de Clase B. Este equipo genera, usa y puede irradiar energía de radiofrecuencia y, si no se instala y usa conforme a las instrucciones, puede generar interferencia dañina con las radiocomunicaciones.
  • Page 24: Ubicación De Los Controles

    1. Enchufes LINE IN y DC IN 15V Z (Parte Posterior de la Unidad) (AC Adapter No. pieza 295-05220-E000*) 2. Altavoz Izquierdo (1 de 2) 3. Compartimento iPod con Conector & Puertos Universales Intercambiables 4. Altavoz Izquierdo (2 de 2) 5.
  • Page 25 REMOTO 1. Botón de Encendido 2. Botón VOL – 3. Botón Skip/Buscar o 4. Botón Reproducir/Pausa (®p) 5. Botón LUZ 6. Transmisor Remoto (Parte superior de la Unidad) 7. Botón VOL + 8. Botón Skip/Buscar n 9. Botón SILENCIO 10.Botón DORMIR 11.
  • Page 26: Fuente De Energía

    CONEXIÓN A CORRIENTE ELÉCTRICA Inserte el extremo pequeño del adaptador CA en el conector de entrada de 15VCD (ubicado atrás en la unidad). Conecte el otro extremo al contacto eléctrico de 120VCA, 60 Adaptador CA, 15VCD Z NOTAS: • Cuando no vaya a utilizar la unidad, desconecte el adaptador de corriente alterna de ambos lados.
  • Page 27: Conexión Opcional

    INSTALACIÓN DE LAS BATERÍAS EN EL CONTROL REMOTO Cuando use baterías, tome las siguientes precauciones: 1. Advertencia: Riesgo de explosión si la batería se reemplaza de modo incorrecto. Reemplazar sólo con una batería del mismo tipo o equivalente. 2. Use únicamente el tamaño de batería que indica el fabricante. 3.
  • Page 28 Ubique el puerto universal correcto a usar como se muestra en la página 15. Inserte el puerto universal (A) en el compartimiento de iPod (B) (como se muestra), asegurándose de que las dos pestañas del puerto apunten al frente y deslícelas hasta que queden en su lugar.
  • Page 29: Operación

    USAR UN iPod CON ESTA UNIDAD Con un iPod conectado (vea página anterior), si esta unidad no está ya encendida, encienda presionando el botón de Encendido del mando a distancia (mostrado) o en la unidad principal; “iPod” aparecerá en la pantalla. Reproducir/pausar el iPod: Presione el botón Reproducir/ Pausa (®p)
  • Page 30 AJUSTAR EL VOLUMEN Para ajustar el volumen principal: Presione el botón VOL + 1 y/o - 2 del mando a distancia (mostrado) o el botón VOL +/MIN y/o -/HR de la unidad principal para aumentar y/o disminuir el volumen. Para silenciar el volument principal: Presione el botón de SILENCIO 3 en el mando a distancia;“SILENCIO”...
  • Page 31 CONFIGURAR O RESTAURAR EL HORARIO ACTUAL Cuando esté apagado, presione el botón CONFIGURAR TIEMPO/ Skip/Buscar parpadeará. Presione el botón CONFIGURAR TIEMPO/Skip/Buscar o (o espere aprox. 15 segundos) y el horario estará configurado. Dentro de 15 segundos, presione el botón VOL +/MIN 1 para configurar el minuto presente y el tiempo botón VOL -/HR 2 para configurar...
  • Page 32 CONFIGURAR O RESTAURAR EL HORARIO DE ALARMA Cuando esté apagado, presione el botón CONFIGURAR ALARMA /Skip/Buscar n el tiempo de Alarma parpadeará. La configuración del volumen aparecerá Seleccione el máximo nivel de volumen deseado (nivel 1 a 15) para despertarse usando el botón VOL +/MIN 1 y/o -/HR 2.
  • Page 33 Si establece iPod, inserte el iPod como se muestra en la página 7. Seleccione su pista favorita y asegúrse que tanto el iPod como esta nidad están apagados. Cuando se llega a la hora de alarma, esta unidad empezará a reproducir el sonido de la pista seleccionada y las pistas que siguen en la lista de reproducción.
  • Page 34 APAGAR LA ALARMA Si la alarm estaba en VIBRADOR, presione el botón de encendido 1 o el botón de ALARMA 2 y le alarma se apagará y se configurará para el día siguiente. Para NO configurar la alarma para el día siguiente, presione al botón de ALARMA 2 repetidamente para seleccionar el apagado de alarma (sin indicador en...
  • Page 35 DORMIR Con la unidad en el modo LINE IN o iPod, presione el botón DORMIR del mando a distancia; aparecerá "10" en la pantalla durante unos pocos segurndos. Presione de manera repetida el botón DORMIR para característica DORMIR (“DORMIR” aparecerá en la pantalla) y seleccione el horario DORMIR, 20-60 minutos (p.ej, "20"–se apaga...
  • Page 36 PUERTOS UNIVERSALES DE iPod Ubique su iPod en la tabla a continuación y seleccione el puerto universal respectivo (el número del puerto universal está grabado en la parte delantera de éstos, como se muestra en la siguiente página) que corresponde con su iPod. Inserte el puerto universal correspondiente así...
  • Page 37 OPERACIÓN (CONTINÚA) IMPORTANTE: El número de puerto universal está grabado en la parte posterior de los mismos. Consulte la ilustración a continuación en cuanto a la ubicación del número de puerto universal...
  • Page 38: Guía De Diagnóstico

    Si tiene problemas con esta unidad, revise la tabla a continuación antes de llamar a servicio. SINTOMA iPod sin sonido. iPod no se carga. Horario restaurado a “12:00”. La Alarma no se enciende. CAUSA Volume configurado al mínimo o silenciado. Concectado incorrectamente.
  • Page 39: Especificaciones

    SERVICIO AL CLIENTE AL (954) 660-7100. CONSERVE EL EMPAQUE AL MENOS DURANTE 90 DÍAS POR SI ACASO NECESITARA DISTRIBUIDOR O A MEMOREX. PARA OBTENER PIEZAS REEMPLAZABLES POR EL CONSUMIDOR, CONSULTE EL NÚMERO DE PIEZA EN LAS PÁGINAS 3, 4 Y 15 Y LUEGO COMUNÍQUESE...
  • Page 40 Memcorp, Inc. Weston, FL Printed in / Impreso en Hong Kong Visit our website at / Visite nuestro sitio web en www.memorexelectronics.com 201-05220-E010...
  • Page 41 Mi2001 User’s Guide Guía del usuario Alarm Clock and Home ® Speaker System for iPod with Remote Control Reloj de Alarma y Sistema de Bocina Residencial es para iPod ® con Control Remoto Before operating this product, please read these instructions completely.
  • Page 42 Memcorp, Inc. Weston, FL Printed in China Memcorp, Inc. Weston, FL Impreso en China...

This manual is also suitable for:

Mi2001

Table of Contents