Advertisement
Buttons to control Serato Flip
DDJ-SX2
[6]
[1] FLIP REC button
Press:
Flip is ready for recording.
･ Press the [FLIP REC] button again to finish recording a Flip.
When Flip Loop is enabled, Flip Loop playback starts as soon
as the Flip recording is finished.
[SHIFT] + Press:
Enable and disable Flip Loop.
[2] FLIP START button
Press:
Flip is enabled to start the playback from the beginning of the Flip.
･ Press this button during Flip playback to return the Flip to its beginning.
[SHIFT] + Press:
Flip is enabled and disabled.
Even when a Flip is enabled, the Flip will not start until the track reaches
to the beginning of the recorded Flip.
[3] FLIP SLOT button
Press:
Flip slots are switched.
If you save a Flip in a Flip slot in advance, you can call the Flip later.
･ Up to 6 Flips can be saved in Flip slots.
･ In order to call a Flip in a Flip slot, you need to have a vacant
temporary storage area to temporarily store the recorded Flip data.
If any data already exists in the temporary storage area,
save such data to a Flip slot or press the [FLIP REC]
button twice to empty the temporary area.
･ Select a slot where a Flip you want to call is saved and press
the [FLIP START] button to start playback of the saved Flip.
[SHIFT] + Press:
A Flip recorded in the temporary storage area is saved in a slot.
[3]
[1]
[2]
[4]
[5]
[4] PARAMETER (left) button
Press this button to trigger the same action as the [FLIP REC] button
only when HOT CUE mode / SAVED FLIP mode is selected.
[5] PARAMETER (right) button
Press this button to trigger the same action as the [FLIP START] button.
only when HOT CUE mode / SAVED FLIP mode is selected.
[6] HOT CUE mode button
When the [HOT CUE] mode button is pressed during HOT CUE mode:
SAVED FLIP mode is activated.
When the [HOT CUE] mode button is pressed during SAVED FLIP mode:
HOT CUE mode is activated.
･ In SAVED FLIP mode, a Flip in a slot can be called directly by pressing
the performance pads. Please see the section: [Using Saved Flip] for
further details.
4
4
Advertisement
