Table of Contents
Advertisement
THE FOLLOWING PAGES DETAIL COMMON CABINETRY SCENARIOS
CABINETRY DIMENSIONS
5a
Underbench (ie installed with a F&P 60cm wide single oven)
720 mm
Cabinetry dimensions
(mm)
M
minimum inside height of cavity
(with F&P 60cm wide single oven)
N
inside width of cavity
O
minimum inside depth of cavity
Note: When installed in combination with a companion product the companion product may be placed directly onto the
warming drawer. It is not necessary to place a shelf between the products. A built- in shelf at the base of the cabinetry able to
support the weight of both products is required.
* PO - POWER OUTLET. Ensure there is an accessible earthed power outlet within 900 mm of the centre rear of the product.
** In some instances the front cabinetry rail may need to be removed to enable installation.
Oven
M
Warming Drawer
**
Oven
*PO
Warming Drawer
SIDE
687
560
565
N
O
Oven support
brackets
TOP
Fit the supplied oven support brackets
Oven support bracket
Important!
If installing under an oven, you must first fit the two supplied
Oven support brackets to the sides of the Warming Drawer.
The brackets help support the rear of the oven.
Unscrew the 3 top screws on each side, fit the brackets with the
tabs facing inwards as shown and screw back in.
Note: The screws may not be identical. Replace each screw into
its original hole position.
6
Tab
Unscrew-fit-
rescrew
Advertisement
Table of Contents
