Settingupyour TV
89
Displayi_
TVstams inJbrmation
NOTE
°:,, T hesignalinformation banner w ill appear w henthisfeature isset
to Onandyouwatchan HDMI ® inputandpress theINFObutton.
Thesignalinformation will disappear a fterapproximately 60
seconds.
¢ If youpress theINFObuttonwhenthis feature is setto Off,only
thenormal b anner will appear.
Displaying TVstatusinformation
To display TV status information using the RECALL button:
o:* Press the RECALL button on the remote control.
The following information will be displayed (if applicable):
o!. Current input (ANT/CABLE, Video, etc.)
o!. If ANT/CABLE is the current input, either"CABLE"
(for cable
TV) or "ANT" (for over-the-air broadcasts).
o!. Channel number (if in ANT/CABLE
mode)
o!. Digital signal strength indicator (bar graph in lower right
corner of box; for digital signals only)
o:* Stereo, Mono, or SAP audio status (when in HDMP input
mode, Dolby _ Digital, or PCM)
o!. Video resolution
o!. Aspect ratio of incoming video signal (4:3 or 16:9)
o!. V-Chip rating status
•:* GameYimer (if set)
To close the Recall screen, press the RECALL button again.
To display TV status information using INFO, press the INFO
button.
The following additional information will display for digital
channels, if applicable:
•.** Title
o***Duration