Table of Contents
Advertisement
10) BATTERY
If you want to erase CMOS...
1. Turn OFF the com puter and unplug the power cord.
2. Rem ove the battery, wait for 30 second.
3. Re-install the battery.
4. Plug the power cord and turn ON the computer.
11) F_AUDIO (Front Audio Connector)
If you want to use Front Audio connector, you must rem ove 5-6, 9-10 Jumper.
In order to utilize the front audio header, your chassis must have front audio connector. Also please
make sure the pin assigment on the cable is the same as the pin assigment on the MB header. To
find out if the chassis you are buying support front audio connector, please contact your dealer.
Please note, you can have the of using front audio connector or of using rear audio connector to
play sound.
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the sam e or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to the
manufacturer' s instructions.
Pin No.
2
1
9
10
- 21 -
Hardware Installation Process
+
Definition
1
MIC
2
GND
3
REF
4
Power
5
Front Audio (R)
6
Rear Audio (R)
7
Reserved
8
No Pin
9
Front Audio (L)
10
Rear Audio (L)
Advertisement
Table of Contents
