DFI-ITOX G7V300-P User Manual page 74

3
BIOS Setup
On-Chip Serial ATA Setting
On-Chip Serial ATA
Disabled
Auto
Combined Mode This option allows you to use both IDE and
Enhanced Mode This option allows you to use both IDE and
SATA Only
PATA IDE Mode
This field is used to select the function mode for the IDE
connector and its relation to the SATA ports.
Primary
Secondary
SATA Port
If the "PATA IDE Mode" field is set to Primary, this field will
show "P1, P3 is Secondary"; meaning SATA 2 and SATA 4 are
Secondary.
If the "PATA IDE Mode" field is set to Secondary, this field will
show "P0, P2 is Primary"; meaning SATA 1 and SATA 3 are
Primary.
74
Disables the onboard SATA.
The system will detect the existing SATA and
IDE drives then automatically set them to the
available master/slave mode.
SATA drives; allowing a maximum of 4 drives -
1 IDE Master, 1 IDE Slave and 2 SATA;
suppor ting maximum of 2 drives on each
channel.
SATA drives; allowing a maximum of 6 drives -
1 IDE Master, 1 IDE Slave and 4 SATA.
This option automatically sets the SATA drives
to Primary Master mode. Since the SATA
drives are in Master mode, you cannot set the
IDE drive to Master mode.
IDE serves as Primary Master and Primary
Slave channel. SATA 2 and SATA 4 serve as
Secondary Master and Secondary Slave channel.
SATA 1 and SATA 3 are disabled.
IDE ser ves as Secondar y Master and
Secondary Slave channel. SATA 1 and SATA 3
serve as Primary Master and Primary Slave
channel. SATA 2 and SATA 4 are disabled.