Operating Instructions; Tool Set Up; Batteries; Headphones - Harbor Freight Tools 62307 Owner's Manual And Safety Instructions

Operating Instructions

Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.

Tool Set Up

or installing accessories.
Threaded Insert (20)
Upper Leg (13)
Figure 2
Note: When adjusting the length of the Metal
Detector, be careful to keep the plastic Tapered
Bushing (15) in place with the smaller end
toward the smaller end of the Lock Nut (16).
1. To attach the two legs, slide the Threaded Insert
(20) over the end of the Upper Leg (13), making
sure that the tabs inside the Insert lock into the cut-
outs at the end of the leg. Insert the tapered end
of the Tapered Bushing (15) into the Lock Nut (16)

Batteries

1. Make sure the On/Off/Volume control is set
to OFF. Slide the Battery Cover (21) off of
the back of the Control Box and insert six AA
batteries (sold separately), aligning polarities
as indicated. Replace the Battery Cover.
Note: Use only fresh batteries of the required size
and type. Do not mix old and new batteries, different
types (standard, alkaline, or rechargeable), or
rechargeable batteries of different capacities.
Always remove old or weak batteries. Batteries can
leak chemicals that can destroy electric parts.

Headphones

1. Insert headphone (sold separately)
jack into Earphone socket.
2. To protect your hearing, set the On/Off/
Volume Control to OFF before using the
earphones, then adjust the level to the
lowest setting before you begin listening.
Item 62307
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off and remove the batteries before adjusting tool
Lock Nut (16)
Tapered Bushing (15)
For technical questions, please call 1-888-866-5797.
and lightly thread the Nut over the Threaded Insert.
Slide the Lower Leg (10) into the Lock Nut. To
take the slack off the cord, rotate the Lower Leg,
enabling the cord to wind around the two Legs.
Rotate the Nut counterclockwise to lock the Legs.
2. To adjust the length of the Legs, turn the Lock
Nut in a clockwise direction, slide the Lower Leg
to the desired extension length and turn the Nut
counterclockwise to secure the Legs together.
3. To adjust the angle of the Search Coil, loosen
the Coil Pivot (17) and Knob Bolt (18) and tilt it.
Position the Search Coil so that it is parallel to
the ground when holding the unit by the Handle
with your arm in the Arm Support (12).
4. If needed, re-adjust the length of the Metal Detector
after adjusting the position of the Search Coil.
If you do not plan to use the detector for a
week or more, remove the batteries.
Dispose of spent batteries according to your
local, state and federal regulations.
Note: You can extend battery life by using earphones,
which require less power than the built-in speaker.
Note: Replace batteries when the LOW BATT
light turns on in the View Meter (1).
3. Do not listen at extremely high volume
levels. Extended high volume listening
can lead to permanent hearing loss.
4. Do not wear headphones while operating
your detector near high-trafffic areas.
Pay attention to traffic safety.
Page 5