Hands Free Speakerphone; Led Light Indicator; Troubleshooting - AT&T LoudSpeak’r BTS01 User Manual

Operational Instructions

Hands Free Speakerphone

- Outgoing calls
To place a call, simply initiate the call from your compatible Bluetooth phone and the
call will automatically be routed through your paired LoudSpeak'r.
- Incoming calls
Press to answer the call on your speaker.
•
Press and hold to reject the call.
•
- During a call
Press to hang up.
•
Press and hold to route the call back and forth between your phone and the
•
speaker.
Double press to answer call waiting.
•
Double press to toggle between the original call and the new call.
•
Press or at anytime during the call to mute your microphone. The light
•
indicator will blink blue.
Led Light Indicator (on front of speaker)
- No light: Power OFF
- Flashing blue & red: Paring Mode
- Solid blue: Power ON (Battery level>30%)
- Solid red: Power ON (Battery level<30%)
- Blinking red/Auto power OFF in 5 mins: Power ON (Battery level<10%)
- Flashing blue: Charging
- No light: Power OFF + fully charged
Page 10

Troubleshooting

Symptom Solution
Music is not streaming
Make sure your Bluetooth device has A2DP profile.
over Bluetooth Check if both devices are paired and connected over Bluetooth.
Restart the LoudSpeak'r to auto-connect with your Bluetooth device.
No power Make sure LoudSpeak'r is fully charged.
LoudSpeak'r doesn't Make sure your mobile device has HSP/HFP profile.
answer phone calls Check if both devices are paired and connected over Bluetooth.
Restart the LoudSpeak'r to auto-connect with your Bluetooth device.
Music doesn't resume Press play to resume music.
after hanging up
a call
No music control by Make sure your Bluetooth device has AVRCP profile.
LoudSpeak'r
Remarks:
If troubleshooting does not eliminate the problem, shut down the speaker by sliding the switch on
the back to OFF . In case the problem still exists, see warranty information on page 15 to obtain
service.
Page 11