Advertisement
COUPLING OF THE PANELS OF THE BUILT-IN
COLUMN TO THE DOORS OF THE APPLIANCE
The appliance is equipped with coupling devices for the appliance
doors with the panels of the column (drive sleds).
Fasten the sled in the inner part of the panel of the built-in column at the
desired height and at approx. 20 cm. From the outer wire of the door
Open the doors of the built-in column and the fridge. Position the
built-in loader in the slide, then fi t it into the fridge door
Mark the fi xing points for the screws and drill with a bit of a diameter
of 2.5
Connect the appliance door to the cabinet panel using the sled slots
as references.
PRECAUTIONS FOR THE CORRECT
Once the product has been built in, position the rear part of the column
in contact with the wall so as to prevent access to the compressor
compartment.
For the product to operate correctly it is essential to allow adequate air
circulation so as to cool down the condenser located in the rear part of
the appliance.
For this reason, the column must be equipped with a rear chimney, whose
upper opening must not be blocked and with a front slot which will be
covered with a ventilation grill.
Dimensions of the column lock-pickings
380x50mm
Dimensions of the gap to be left between the column and the
ceiling
Z STUDIO > 04-2009 – Cod. 41031853
FUNCTIONING
540x50mm
540x50mm
380x37mm
50mm
Advertisement
