Connecting Audio Output - VocoPro IR-9009 Owner's Manual

Connecting Audio Output

There are 3 outputs available from which to get audio: the individual (Ch . 1 /Ch .2) channel outputs and the
single mixed output . Depending on which jacks are used will determine the amount of volume control on the
mixer/sound system .
USING THE MIXED OUTPUT
1 . Ensure main power switch is set to the OFF position .
2 . Connect one end of the included 1/4" - 1/4" patch cable to the 1/4" output jack labeled MIXED on the
back of the IR-9009 Receiver .
3 . Connect the other end of the 1/4" - 1/4" patch cable in to the desired microphone input on the mixer/
sound system .
(Example of Mixer Inputs)
USING THE INDIVIDUAL CHANNEL OUTPUT
1 . Ensure main power switch is set to the OFF position .
2 . Connect one end of the included 1/4" - 1/4" patch cable to the 1/4" output jack labeled CH . 1 on the back
of the IR-9009 Receiver .
3 . Connect the other end of the 1/4" - 1/4" patch cable into the desired microphone input on the mixer/
sound system .
4 . Repeat steps 2 & 3 for the CH . 2 1/4" jack .
(Example of Mixer Inputs)
use of this jack
disables front sensor
use of this jack
disables front sensor
10