Remote Control; General - Insignia NS-19D220NA16 User Manual

Problem Solution
Good sound, but
• Adjust the contrast, color, and
poor color.
Audio noise.
• Other devices (for example, a
No output from
• Adjust the audio balance. See
one of the
speakers.
• Make sure that the audio cables
After images
• Do not display a still image,
appear.

Remote control

Problem Solution
Remote
• Make sure that the power adapter is
control does
plugged into a working outlet.
not work.
• Make sure that there are no
obstructions between the remote
control and the remote control
sensor on the front of the TV.
• Point the remote control directly at
the remote control sensor on your
TV. For the location of the remote
control sensor, see
remote control
• The supplied batteries are wrapped
tightly in clear plastic. Make sure
that you have removed this plastic
from the batteries.
• Make sure that the batteries are
installed correctly. See
remote control batteries
page 31.
• Replace dead batteries with new
batteries. See
control batteries
67
brightness settings. See
Adjusting the TV picture on
page 44.
surround sound receiver,
external speakers, fans, or hair
dryers) may be interfering with
your TV. Try turning off one
device at a time to determine
which device is causing
interference. After you have
determined which device is
causing interference, move it
further from the TV to eliminate
the interference.
Adjusting sound settings on
page 46.
are connected correctly and
securely to your TV.
such as a logo, game, or
computer image, for an
extended period of time. This
can cause a permanent
after-image to be burned into
the screen. This type of damage
is not covered by your warranty.
Aiming the
on page 31.
Installing
on
Installing remote
on page 31.
www.insigniaproducts.com
Problem Solution
Trouble
• See instructions in
programming
universal remote controls
your existing
page 32.
universal
• Codes are subject to change. For
remote
up-to-date codes, go to
control.
universal remote control codes
page 32, or visit
www.insigniaproducts.com/remotecodes
• Replace dead batteries with new
batteries.
• Refer to the User Guide that
accompanied your universal remote
control and contact the
manufacturer if problems persist.

General

Problem Solution
No power.
• Make sure that the power
• Unplug the power adapter, wait
• Other devices (for example, a
"No signal"
• Press INPUT and make sure that
error message is
displayed.
• If you are using a cable or
After Auto
• Reception can vary by channel
Channel Search,
there are no
channels.
• Make sure that the antenna or
• Try replacing the cable between
Insignia 19" 720p 60Hz LED TV
Programming
on
Viewing
adapter is plugged into a
working outlet.
60 seconds, then plug the
adapter back in and turn on
your TV.
surround sound receiver,
external speakers, fans, or hair
dryers) may be interfering with
your TV. Try turning off one
device at a time to determine
which device is causing
interference. After you have
determined which device is
causing interference, move it
further from the TV to eliminate
the interference.
you have selected the correct
input for the device or service
you are trying to use.
satellite box, use the remote
that came with that box to
change channels.
depending on the broadcast
power level of a given station.
Contact your cable or satellite
TV provider.
cable/satellite TV is connected
securely to your TV.
the antenna/cable or
cable/satellite box and your TV.
on