Asus P5LD2-DH User Manual page 66

Allocate IRQ to PCI VGA [ Yes]
When set to [Yes], BIOS assigns an IRQ to PCI VGA card if the card
requests for an IRQ. When set to [No], BIOS does not assign an IRQ to the
PCI VGA card even if requested. Configuration options: [No] [Yes]
Palette Snooping [Disabled]
When set to [Enabled], the pallete snooping feature informs the PCI
devices that an ISA graphics device is installed in the system so that the
latter can function correctly. Configuration options: [Disabled] [Enabled]
PCI IDE BusMaster[Enabled]
Allows BIOs to use PCI bus mastering when reading/writing to IDE devices.
Configuration options: [Disabled][Enabled]
O ffBoard PCI/ISA IDE Card[Auto]
Allows you to configure the offboard PCI/ISA IDE card.
Configuration options: [Auto][PCI Slot1][PCI Slot2][PCI Slot3]
[PCI Slot4][PCI Slot5][PCI Slot6]
IRQ -xx assigned to [PCI Device]
When set to [PCI Device], the specific IRQ is free for use of PCI/PnP
devices. When set to [Reserved], the IRQ is reserved for legacy ISA
devices. Configuration options: [PCI Device] [Reserved]
DMA Channel X [PCI Device]
Allows you to configure the DMA channel.
configuration options: [PCI Device] [Reserved]
Reser ved Memor y Size [Disabled]
Allows you to set the reserved memory size.
configuration options: [Disabled][16k][32k][64k]
Ac tive State Power-Management [Disabled]
Allows you to enable or disable the active state power-management.
Configuration options: [Disabled][Enabled]
2-22 Chapter 2: BIOS setup