Advertisement
ASSEMBLY INSTRUCTIONS
1. Remove all packaging material and wire fastener from the product.
2. Drill 3 holes on the wall with a distance complied with the hole on the wall bracket (2).
3. Press the screw anchors provided into holes.
4. Mount the hanging bracket (2) on the wall with three screws (1) provided (Fig 1).
5. Hang the rear motor (3) with the holes (11) fixed onto the hanging bracket (2) (Fig 2).
6. Remove the protecting tube (12) from the motor shaft.
7. Loosen the rear guard locking nut (5) from the motor & housing assembly (A).
8. Position the rear guard (4) firmly to the motor & housing assembly (A) and fasten by
turning the rear guard locking nut (5) clockwise tightly.
9. Push the fan blade (6) along the motor shaft. Fasten securely using the fan blade locking
nut (7) by turning anticlockwise.
10.
Press the front guard (8) to attach with rear guard (4) until both guards are properly fitted
(Fig 5). Secure both guards firmly by tightening the guard ring clip (9) (Fig 6).
(Fig 1)
(Fig 3)
(Fig 5)
(Fig 2)
(Fig 4)
(Fig 6)
Advertisement
