Table of Contents
Advertisement
IV. BIOS SOFTWARE
External Cache
These fields allow you to Enable (default) or Disable the CPU's "Level 2" second-
ary cache. Caching allows better performance.
Quick Power On Self Test
This field speeds up the Power-On Self Test (POST) routine by skipping retesting a
second, third, and forth time. Setup default setting for this field is Enabled. A
complete test of the system is done on each test.
HDD Sequence SCSI/IDE First (New Feature!)
When using both SCSI and IDE hard disk drives, IDE is always the boot disk using
drive letter C (default setting of IDE). This new feature allows a SCSI hard disk
drive to be the boot disk when set to SCSI. This allows multiple operating systems
to be used on both IDE and SCSI drives or the primary operating system to boot
using a SCSI hard disk drive.
Boot Sequence
This field determines where the system looks first for an operating system. Options
are C,CDROM,A; CDROM,C,A; A,C; C,A The setup default setting is to check first
the hard disk and then the floppy drive; that is, C, A.
Swap Floppy Drive
When enabled, the BIOS swaps floppy drive assignments so that Drive A becomes
Drive B, and Drive B becomes Drive A under DOS. By setup default, this field is set
to Disabled.
Boot Up Floppy Seek
When enabled, the BIOS will seek the floppy "A" drive one time. By setup default,
this field is set to Disabled.
Floppy Disk Access Control
This allows protection of files from the computer system to be copied to floppy
drives by allowing the setting of Read Only to only allow reads from the floppy but
not writes. The setup default R/W allows both reads and writes.
Boot Up NumLock Status
This field enables users to activate the Number Lock function upon system boot.
The setup default setting for this field is On.
Boot Up System Speed
This has not function and should be left at the setup default of High.
IDE HDD Block Mode Sectors
This field enhances hard disk performance by making multi-sector transfers instead
of one sector per transfer. Most IDE drives, except older versions, can utilize this
feature. By setup default, this field is set to HDD MAX, other selections are Dis-
abled 2, 4, 8, 16, and 32.
ASUS P/I-XP55T2P4 User's Manual
35
Advertisement
Table of Contents
