Asus P/I-XP55T2P4 User Manual page 30

15. CPU Cooling Fan Connector (FAN)
This connector supports a CPU cooling fan of 500mAMP (6WATT) or less.
Orientate the fan so that the heat sink fins allow airflow to go across the on-
board heat sink(s) instead of the expansion slots. Depending on the fan manu-
facturer, the wiring and plug may be different. The red wire should be posi-
tive, while the black should be ground. Connect the fan's plug to the board
taking into consideration the polarity of the this connector.
WARNING: The CPU and/or motherboard will overheat if there is no airflow
across the CPU and onboard heatsinks. Damage may occur to the mother-
board and/or the CPU fan if these pins are incorrectly used. These are not
jumpers, do not place jumper caps over these pins.
16. IrDA-Compliant Infrared Module Connector (IR CON)
This connector supports the optional wireless transmitting and receiving infra-
red module. This module mounts to a small opening on system cases that
support this feature. You must also configure the setting through BIOS setup
on page 37 UART2 Use Infrared to select whether UART2 is directed for use
with COM2 or IrDA. Use the five pins (as defined by Intel) as shown on the
Back View and connect a ribbon cable from the module to the motherboard
according to the pin definitions.
24
III. INSTALLATION
+12V
GND
+12Volt Power
Connector for
CPU Cooling Fan
NC
GND
Infrared Module Connector
ASUS P/I-XP55T2P4 User's Manual
Front View
+5V
IRRX
IRTX
IRTX
GND
Back View
+5V
NC
IRRX