Table of Contents
Advertisement
7. Serial ATA RAID connectors (7-pin SATA_RAID1, SATA_RAID2,
SATA_RAID3, SATA_RAID4)
The Serial ATA RAID connectors are available on SATA models only.
These Serial ATA connectors support SATA hard disks that you can
configure as a RAID set. Through the onboard Adaptec
RAID controller, you may create a RAID0, RAID1, RAID0+1, or
multi-RAID configuration.
®
PSCH-SR
PSCH-SR SATA RAID Connectors
•
If you wish to create a RAID set, make sure that you have
connected the SATA cable and installed Serial ATA hard disk
drives. You cannot enter the SATARaid™ utility and SATA BIOS
setup during POST if there are no connected Serial ATA HDDs.
•
The Adaptec
devices such as CD-ROMs, DVD-ROMs, etc.
8. LAN LED connector (4-pin LAN_LED1)
This connector is for the LAN activity LEDs in the system front panel.
®
PSCH-SR
PSCH-SR LANLED Connector
ASUS PSCH-SR motherboard
SATA_RAID4
SATA_RAID3
SATA_RAID2
SATA_RAID1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXN1
RSATA_RXP1
GND
®
AIC-8110X RAID controller does not support ATAPI
LAN_LED1
®
AIC-8110X
2-27
Advertisement
Table of Contents
