GE Carry-Cool AT505 Use And Care Manual page 4

-...— - --
<-—
v
Sel*tor switch
OFF turns air conditioner off.
HI FAN permits high fan speed
operation without cooling.
LO FAN permits low fan
speed operation without cooling.
Hi COOL permits cooling with high
fan speed operation.
LO COOL permits cooling with
Jowfan speed operation.
Temperature Controi
When you turn the TEMPERATURE
control to the desired setting, the
thermostat will automatically control
the temperature of the indoor air.
The higher the number selected,
the cooler the indoor air will be.
The Save Energy Range(on models
so equipped) is a visual reminder
that you can conserve energy by
selecting a higher room temperature
but still keep the room cool and less
humid than outside.
ventilation
mntroi
Models
AT505 & AT506
The vent door inyour air conditioner
is closedwhentheVENTpushbutton
is out andto the leftand onlythe air
insidethe room can be circulated
and conditioned. Pushing the VENT
button in and sliding it to the right
opens the vent door, allowing a
small amount of indoor air to be
exhausted from the room.
For normal cooling
1. Set SELECTOR switch at
f-ii COOL.
2. Set TEMPERATURE control at
desired number (usually the mid-
point is a good starting position). If
room temperature is not satisfactory
after a reasonable time, set the
thermostat control at a higher num-
ber for a cooler room or at a lower
number for a warmer room.
3. Be s{~re\/ENTdoor (on rnodeis so
equipped) is closed. VENT button
should be out and to the left.
., *
~"er ma;:imu?m Qoo!ing
";. Set SELECTOR
SWitCh at
!-"!1
COOL,
z.set-rE/\A PER/4Tu RE
control at "!0.
"= 3BE Stire VENT door (on mt:)<lel. s so ~s .
<-:~]~ji~;~~cj) is ~jass:a~. V E[~JTbu~on
For
quieter operation
1. Set SELECTOR switch at
LC)COC)L,
2. Set TEMPERATURE control at
desired number.
Moisture
removal
The moisture that your air condi-
tioner removes from the air drains
to the rear of the cabinet where it
is picked up by a fan and dispersed
against the condenser. Occasion-
ally, more likely during start up, a
"pinging" noise maybe heard.This is
normal for a short time in less humid
areas and longer in very humid
areas. This method of moisture
removal improves the operational
efficiency of your air conditioner.
Note: Before moving your air condi-
tioner to another location, turn it
off and wait 5 or 10 minutes. This
will allow the condensate to drain
from the coil into the base pan.Then,
keeping a firm grip on the air coridi-
tioner, carefully raise the window
and tilt the air conditioner to Ihe
outside to drain the water -from the
base pan.