Installation Requirements; Operating Your Refrigerator - GE SC2 Use And Care Manual

Hide thumbs Also See for SC2:
Table of Contents

Advertisement

Installation Requirements
(continued)
IMPOKI'ANT.
.
Please
Read
Carefully.
U s e
of adapter plug
Because of potential safety
hazards under certain conditions,
we strongly recommend against
use of
an adapter plug. However, if
you still elect to use an adapter,
where local codes permit, a
TEMPORARY
CONNECTION
may
be made to a properly grounded
two-prong wall outlet
by
use of a
UL
listed adapter (Fig. 2) available
at most local hardware stores.
1
(ADAPTER PLUGS NOT
TEMPORARY METHOD
PERMITTED
IN
CANADA)
ALIGN LARGE
-'
INSURE PROPER
GROUND AN0
FIRM CONNECTION
BEFORE USE
Fig. 2
The larger slot in the adapter must
be aligned with the larger slot in
the wall outlet to provide proper
polarity in the connection of the
power cord.
CAUTION: Attaching adapter
ground terminal to wall outlet cover
screw does not ground the appliance
unless cover screw is metal, and
not insulated, and wall outlet is
grounded through house wiring.
You should have the circuit checked
by a qualified electrician to make
sure the outlet is properly
grounded.
When disconnecting the power
cord from the adapter, always
hold the adapter with one hand. If
this is not done, the adapter ground
terminal is very likely to break with
repeated use.
Should the adapter ground
terminal
break,
DO NCrr
USE
the
appliance until a proper ground
has again been established.
Use of extension cords
Because of potential safety hazards
under certain conditions, we
strongly recommend against the
use of an extension cord.
However,
if you still elect to use an extension
cord, it is absolutely necessary that
it be a UL listed 3-wire grounding
type appliance extension cord
having a grounding type plug and
outlet and that the electrical rating
of the cord be 15 amperes (minimum)
and
1 2 0 volts.
The refrigerator
should
always
be
plugged
into its own
individual electrical outlet-
(115 volt,
60
Hertz, single phase
AC). This is recommended for best
performance and to prevent
overloading house wiring circuits,
which could cause a possible fire
hazard from overheating wires.
Refrigerator Installation
b a t i o n
This refrigerator is designed for
free-standing installation only. It
should not be recessed or built-in.
Install the refrigerator on a base
strong enough to support a fully
loaded refrigerator. If the base is
not level, adjust the feet of the
refrigerator.
If the refrigerator is in a
40°F.
or
colder room, it will operate but
it will not cool foods properly.
Also see Energy-Saving Tips
regarding location.
Clearance
Allow the following ciearances
for proper air circulation:
Top, 12"
Back, 5"
Sides,
1/2"
4
Operating Your
Refrigerator
Temperature
Control Dial
The temperature control dial has
settings from
'"IN"
to
"MAX"
plus ''OFTI'
I
MIN
J
"MIN" is the warmest.
"MAX"
is the coldest.
Initially set the temperature
control dial at the midpoint.
After using the refrigerator for
24 hours, adjust the temperature
control to the setting that is best
suited to your needs.
Note:
If this refrigerator is unplugged
or turned off, you must allow 3
minutes before restarting it or
plugging it back in. If you attempt
to restart it in less than 3 minutes, it
will not start.
Note:
Turning temperature control dial to
"OFF"
stops cooling but does not
shut off power to the refrigerator.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ta2Sc4Ta4

Table of Contents