GE JTP85 Use And Care Manual page 36

OPERATING THE SELF-CLEANING OVEN
How to Set Oven for Cleaning
Easy Steps:
1. Press SELF CLEAN.
2. Press the number pads to set the clean time.
3. Press START.
1. Follow the steps in the Before a Clean
Cycle section.
2. Press SELF CLEAN.
SELF
CLEAN
3. Press the number pads to set the clean
time, if a time other than 4 hours is
needed.
Clean time is normally 4 hours. You can
change the clean time to any time
between 3 to 5 hours, depending on the
amount of soil in your oven.
4. Press START.
START
How to Set Delay Start of Cleaning
Easy Steps:
1. Press SELF CLEAN.
2. Press the number pads to set the clean time.
3. Press DELAY START.
4. Press the number pads to set the start time.
5. Press START.
Delay Start is setting the oven to start the clean
cycle automatically at a later time than the present
time of day.
NOTE: Before beginning, make sure the oven clock
shows the correct time of day.
1. Follow the steps in the Before a Clean
Cycle section.
2. Press SELF CLEAN.
SELF
CLEAN
3. Press the number pads to set the
clean time.
36
(continued)
The door locks automatically. The display will show
the clean time remaining. It will not be possible to
open the oven door until the temperature drops below
the lock temperature and the LOCKED DOOR light
goes off.
5. When the LOCKED DOOR light is off, open
the door.
NOTE:
• You can find out when the clean cycle
DELAY
will start by pressing DELAY START.
START
• The display will flash and the control will
beep if you set the clean cycle and forget to
close the oven door.
4. Press DELAY START.
DELAY
START
5. Press the number pads to set the time of
day you want the clean cycle to start.
6. Press START.
The door locks automatically. The
START
display will show the start time. It will
not be possible to open the oven door
until the temperature drops below the
lock temperature and the LOCKED
DOOR light goes off.
7. When the LOCKED DOOR light is off,
open the door.