Serial Number Definition - Philips 170C8FS/00 Service Manual

22
HUDSON 8
8. Click Next , bring up Fig. 43.
- In this step, please confirm the Descriptor Data Type is Monitor
Range Limits, and all the items are same as below.
- Click Finish to exit the Step window.
- Serial number can be filled up at this moment (for example, TY
123456).
Fig. 43
Step 5: Write DDC data
1. Configuration should be as Fig. 40. And press OK.
2. Access Factory Mode
1). Turn off monitor.
2). [Push "AUTO" & "OK" buttons at the same time and hold them]
+[Press "power" button untill comes out "Windows screen" ]
=> then release all buttons
3).Press "OK" button, wait until the OSD menu with Characters
"Smart image" "Factory" (below OSD menu) come on the Screen of
the monitor. as shown in Fig24.
Factory Mode indicator
Fig. 45
3) Push Menu to exit OSD menu. " "
3. Click (Write EDID) icon from the tool bar to write DDC data.
Then wait for 20-30 seconds ,DDC data will be finished Writing.
Step 6: Save DDC data
Sometimes, you may need to save DDC data as a text file for using in
other IC chip. To save DDC data, follow the steps below:
1. Click (Save) icon (or click "file"-> "save as") from the tool bar and
give a file name as shown in Fig. 46.
The file type is EDID46 file (*.ddc) which can be open in WordPad. By
using WordPad, the texts of DDC data & table (128 bytes, hex code)
can be modified. If DDC TEXTS & HEX Table ar completely correct, it
can be saved as *.ddc flie to re-load it into DDC IC for DDC Data
Application.
9 8
9 8
DDC Instructions
2.
Step 7: Exit DDC program
Pull down the File menu and select Exit as shown in Fig. 47.
Fig. 44
Step 8: Turn off the monitor, exit the factory mode.
BOM Code
Panel Supplier
AUO
CPT
LPL(LG)
QDI
CMO
B Z 1 A 0 6 2 5 0 0 0 0 0 1
Fig.46
Click Save.
Fig. 47

Serial Number Definition

CODE
1
2
3
4
5
SERIAL NO
YEAR/WEEK
SERVICE VERSION CHANGE CODE
BOM CODE(BILL OF MATERIAL)CODE
SITE CODE(PRODUCTION CENTER)
BZ CODE(AR-CZECH REPUBLIC
VN-HUNGARY(SZR),BZ-SUZHOU
DS-DONGGUAN)