Konwin Home GD9315BCW-FP Owner's Manual page 6

PREPARATION
Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet. and
turn on the power switch in the rear of the unit. Only operate heater in upright position with
caster wheels attached.
Insert 2 AAA batteries into the remote control before using (Batteries Not Included)
OPERATING INSTRUCTIONS
1、Start and select working mode
Or
Or
Remote Control
Power button: Powers the display on and off
Up button: For setting temperature or time upward
Down button：For setting temperature or time downward
Flame light button: Adjust the brightness of the flame
Heater button: Set up the heater mode and turn off
Timer button: User setting timing boot or shutdown
Turn the heater on by pressing the POWER button on the
control panel or by pressing the Power button on the
supplied remote control.
Once power is off, heating element will stop working at first.
Fan will prolong working for 3 min to emit plenty of heat
inside. This mark will indicate running during the 3 min.
Select a heat setting.
Press the HEATER button to toggle between the two heat
settings.
6