Renault Megane Driver's Handbook Manual page 104

FUNCTION STOP AND START
Special feature of the automatic
engine re-start
Under certain conditions, the engine
can restart on its own in order to gua-
rantee your safety and comfort.
This can occur especially when:
– the outdoor temperature is too low or
too high (less than around 0 °C or
higher than around 30 °C);
– the "Clear View" function is activated
(please see "Automatic Climate
Control" in Section 3);
– the battery is not sufficiently char-
ged;
– the vehicle speed is above 4.34 mph
(7 km/h) (downhill slope etc.) ;
– repeated pressing on the brake
pedal or braking system require-
ment;
– ...
Before getting out of the
vehicle, you must switch
off the ignition by pressing
the engine stop (please see
"Starting, stopping the engine").
2.8
(3/3)
1
2
Deactivating, activating the
function
Press switch 1 to deactivate the func-
tion. The message "Stop & Start deac-
tivated" will appear on the instrument
panel and the integrated warning light 2
on the switch will light up.
Pressing again will reactivate the
system. The message "Stop & Start ac-
tivated" will appear on the instrument
panel and the integrated warning light 2
on the switch 1 will go out.
Note: With the engine on standby,
press switch 1 to automatically re-
start the engine.
The system reactivates automati-
cally each time the vehicle is started
using the start button (please refer
to "Starting, stopping the engine" in
Section 2).
Operating faults
When the message "Check Stop &
Start" appears on the instrument panel
and the integrated warning light 2 lights
up on the switch 1, the system is deac-
tivated.
Please consult an authorised dealer.
In the event of an emer-
gency, the engine can be
restarted by pressing on the
clutch pedal if the Stop and
Start function is activated.
Deactivate the Stop and
Start function when perfor-
ming any operations in the
engine compartment.