Aiwa 6ZG-1 Service Manual page 4

3. The disassemble and reassemble the TRAY
3-1. Disassembling procedure.
1) Push the PLATE GEAR'S Boss at the bottom part of
CHAS MECHA strongly to the outside (arrow "b"
direction). (Fig-3)
(Confirm that TRAY appears a little in the front.)
2) Draw TRAY to the open position.
3) Remove FFC, and push the two LEVERS at both side of
the CHAS MECH to remove TRAY. (Fig-4)
3-2. Reassembling procedure.
1) Confirm that LEVER TRAY is at the most right position
and check for the CD Mechanism to be in the down
position. (Fig-5)
2) Push in the TRAY along the rail of the CHAS MECHA.
BOSS
TRAY
5CD CHANGER BLOCK
LEVER
LEVER
Fig-4
TRAY
LEVER TRY
Fig-5
4
b
FFC
3) After TRAY is half closed and FFC is put in, it can enter
by force until the end of TRAY closed. (Fig-6)
FFC
Fig-3
Fig-6