Table of Contents
Advertisement
11
DISC SELECT button
Select the desired CD in CDC(CD changer) mode.
1 2
SC/PS button
Scan tuning. Preset scan tuning. Scan play in CD mode.
1 3
AUD button
Audio control selector; Bass, Treble, Loudness, Balance
& Fader.
1 4
Dial
Adjusts the volume level/bass/treble/balance/fader.
Storing the station names. Select Alfa-numeric charac-
ters.
General Operations
Turning the power On/Off
Press the
to turn on or off the unit.
PWR
Tip
When you turn on the unit, "HELLO" will be diplayed then
"WELCOME" will momentarily be displayed before actual
power on.
When you turn off the unit, "SEE YOU" will be diplayed then
"GOOD-BYE" will momentarily be displayed before actual
power off.
You can edit these message. (See "Turn on/off message
edit")
Volume Level Control and Memory
Rotate the dial to adjust the volume.
It is also possible to set the maximum volume for when the
power is switched on by following the procedure explained
below.
1.
Turn the dial until it is set at the required volume.
Volume down
Volume up
2.
Press the
for two or more seconds. The power will
PWR
be switched off and the specified volume level recorded.
However, if the volume exceeds the set value the next
time the power is switched off, the volume setting will be
used when switched on again, and if the volume is lower
than the set value when switched off, it will use that vol-
ume the next time it is switched on.
Muting the sound
Press
.
MUTE / SENS
" MUTE " appears on the display window.
To restore the previous volume level, press
Setting the Clock
The clock uses a 12-hour display system. (factory set)
1.
Turn the ignition key to the ON position.
2.
Press the
PWR
3.
Repeatedly press the
4.
Rotate the dial within 5 seconds to select the 12 or 24-
hour time mode. Each time you rotate the dial, the mode
changes or toggles as follows :
CLOCK 24
CLOCK 12
5.
Repeatedly press the
A. Press the
MUTE / SENS
B. Rotate the dial to set the hour digit.
C. Press the
D. Rotate the dial to set the minute digit.
6.
Press the
DISP
mode.
Note
If you make no button input or dial operation in 20 seconds,
the Clock setting mode will turn off automatically.
Ignition-off Clock Recall
The display will illuminate showing the time and then auto-
matically shut off after 5 seconds.
Press the
while the ignition switch is in the " OFF " po-
DISP
sition.
again.
MUTE / SENS
to turn on the unit.
to display " CLOCK 12 ".
DISP
to display " CLK ADJ ".
DISP
within 5 seconds to flash the hour digit.
to flash the minute digit.
MUTE / SENS
momentarily to quit the Clock setting
E-3
Advertisement
Table of Contents
