Panasonic KX-TG2730CS Operating Instructions Manual page 25

PQQX13405ZA-BM-2E 02.6.4 3:42 PM ページ 25
3 When finished, press
≥The unit will automatically play back the recorded greeting.
≥You can also finish recording by pressing (STOP).
≥To change the greeting, start again from step 1.
" "
is displayed, 6 beeps sound and "Your greeting was not recorded. Record
≥If
your greeting again." is announced, start again from step 1.
To adjust the speaker volume:
9 levels (0–8) are available while using the
Answering System. To increase, press
To decrease, press
To check the recorded greeting message
(GREETING)
Press .
≥The greeting message will be played.
To erase the recorded greeting message
(GREETING)
Press , and then press
played.
≥The unit will answer a call with a pre-recorded greeting message.
Pre-recorded greeting message
If you do not record a greeting message (p. 24), one of two messages will
be played when a call is received, depending on the caller's recording
time (p. 26).
To check the pre-recorded greeting, press
≥A pre-recorded greeting will be played as follows:
I When the recording time is set to "1 minute", "2 minutes" or "3 minutes":
"Hello, we are not available now. Please leave your name and phone number
after the beep. We will return your call."
I When the recording time is set to "Greeting only":
"Hello, we are not available now. Please call again. Thank you for your call."
Flash Memory Message Backup
Messages are stored on a "flash memory" IC chip and will not be
affected by power failures. All messages are saved until you erase them.
(GREETING)
.
(‹)
.
(›)
.
(ERASE)
while the message is being
"
e.g. Level 8
FULL
RINGER
OFF
1 2
BOX BOX BOX
(GREETING)
.
3
25