Safety Warnings - Dimplex DHCB20 Instruction Manual

2. Safety warnings


Please operate the heater on a dry even surface

This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instructions
concerning the use of the appliance by a person responsible for their

Disconnect the heater from mains when not in use or when cleaning.

Do not operate the appliance with a damaged cord or plug. If the power supply cord is
damaged, it must be replaced by the manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard.

Do not use an extension cord with this heater.

Do not immerse cord, plug or any part of the appliance in water or any other liquid.

Do not place the heater on or near any other source of heat.

Warning: in order to avoid overheating, do not cover the heater. This may cause
the unit to overheat

Do not operate the heater below a wall socket-outlet.

Do not use outdoors.

When the heater is turned on for the first time, it may release a slight,
harmless odour. This odour is a normal occurrence caused by the initial
heating of the internal heating elements and should not occur again.

Do not operate heater in areas where flammable liquids are stored.

Do not attempt to repair, disassemble or modify the appliance. There are no
user-serviceable parts inside.

Do not insert or allow foreign objects to enter the ventilation or exhaust openings as
this may cause an electric shock , fire or damage to the appliance.

Do not use this heater with a programmer, timer or any other device that switches the
heater on automaticlally

Turn off the heater when not in use

When using the heater, keep away from curtains, drapes, clothing, bedding and other
such materials to avoid fire. Keep any combustible materials at least 1 metre away
from the heater.

The power supply, voltage and frequency must comply to the main technical
specifications of the heater.

If there is a fault, please do not attempt to disassemble the product, or replace the
spare parts. Please contact the manufacturer or its service agent.

The heater must be installed at least 1,8 m above the floor in accordance to local
Electrical wiring regulations and wiring rules.

The heater is to be installed so that switches and other controls cannot be touched by
person in the bath or shower.
2