Download Table of Contents Print this page

Before Setting Oven Controls - Frigidaire FGEW3065PF Use & Care Manual

Advertisement

Table of Contents
Oven vent location
The oven vent is located under the control panel. When the
oven is on, warm air passes through this vent. This venting
is necessary for proper air circulation in the oven and good
baking results. Do not block oven vent.
Figure 1:
Do not block oven vent location
CAUTION
Always use pot holders or oven mitts when using the
oven. When cooking, the oven interior and exterior, oven
racks, and cooktop will become very hot which can cause
burns.
WARNING
Protective Liners — Do not use aluminum foil to line the
oven bottom. Only use aluminum foil as recommended in
this manual. Improper installation of these liners may
result in risk of electric shock or fire.
Removing, replacing, and arranging flat or offset
oven racks
To arrange - Always arrange the oven racks when the oven
is cool (prior to operating the oven).
To remove - Pull the oven rack straight forward until it
reaches the stop position. Lift up front of oven rack slightly
and slide out.
To replace - Place the oven rack on the rack guides on both
sides of oven walls. Tilt the front of oven rack upward
slightly and slide the oven rack back into place. Be sure
oven racks are level before using.

BEFORE SETTING OVEN CONTROLS

BEFORE SETTING OVEN CONTROLS

Type of oven racks
oven vent
location
Figure 2:
Oven Rack Descriptions
Air circulation in the oven
For best air circulation when baking, allow a space of 2
inches (5 cm) around the cookware for proper air circula-
tion. Be sure pans and cookware do not touch each other,
the oven door, sides, or back of the oven cavity.
Hot air must be able to circulate around cookware for even
heat to reach the food.
flat
oven rack
offset
oven rack
Oven rack types
Flat oven racks (or the flat handle oven rack) may be
used for most cooking needs and may be placed in
most oven rack positions.
The offset oven rack (some models) provides additional
stepdown positions from the standard flat rack design.
The offset design positions the base of the rack about 1/
2 of a rack position lower than the flat rack and may be
used in most oven rack positions.
The half rack (some models) design comes with a
removable section that allows for taller cooking utensils.
flat handle
oven rack
half
oven rack
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents