Advertisement
[ ]
Verify green power LED near 24 VAC terminals is lit.
[ ]
Verify green heartbeat LED in middle of panel is pulsing.
[ ]
Verify all 3 zone LEDs near damper terminals are green.
[ ]
Verify supply temp display shows current plenum temperature.
[ ]
Switch zone 1 thermostat to heat mode, and call for heat in zone 1 by raising set
temperature above room temperature.
[ ]
Verify zone 1 damper LED stays green (open) and zone 2 and 3 damper LEDs change
to red (closed).
[ ]
Verify heating system is operating, air is moving out zone 1 vents, and zone 2 and 3
vents have minimal airflow.
[ ]
Verify supply temp display on zone panel shows a heat change in supply air.
[ ]
Switch zone 2 thermostat to heat mode, and call for heat in zone 2 by raising set
temperature above room temperature.
[ ]
Verify zone 1 damper LED stays green (open) and zone 2 damper LED changes to
green (open).
[ ]
Verify heating system is operating and air is moving out into zone 1 and zone 2.
[ ]
If installed, switch zone 3 thermostat to heat mode, and call for heat in zone 3 by raising
set temperature above room temperature. Verify air is now flowing to zone 3.
[ ]
If installed, verify emergency heat remote and panel switch. Return E-Heat switches to
normal position when test is complete.
[ ]
Return zone 1 thermostat to the off position. Verify zone 1 damper LED turns red and
zone 2 and 3 damper LEDs stay green.
[ ]
Verify heating system is operating, air is moving out zone 2 and 3 vents, and zone 1
vents have minimal airflow.
[ ]
Return zone 2 and 3 thermostats to the off position. Verify system fan shuts off at the end
of 90-second purge cycle.
[ ]
Verify all zone LEDs near damper terminals are green.
[ ]
If the outside temperature is acceptable, repeat the above steps in cooling mode.
Cooling will not work if E-Heat is on.
[ ]
Restore thermostats and replace J2 jumper if short cycle protection at zone panel
is required.
8
Advertisement
