Connecting With Your Devices - Dukane 8952P User Manual

Connecting with your devices

Before connecting the projector to your devices, check the manual of the device in
order to make sure that the device is suitable to connect with this projector and to
check what is required for the connection.
Consult your dealer when the required accessory did not come with the product or
the accessory is damaged. It may be regulated under some standard.
After making sure that the projector and the devices are turned off, perform
the connection, according to the following instructions. Refer to the fi gures in
subsequent pages.
NOTE
• For this product, the optional cable cover is ready to be purchased. To
place an order for it, please tell your dealer the type name of it (
WARNING
manufacturer. Modify neither a projector nor accessories.
►Do not connect or disconnect the projector with devices while they are
connected to a power supply except for the cases directed by the manuals of
devices.
CAUTION
or a ferrite core at the end to connect to the projector, under the regulation of
electro-magnetic interference. When a ferrite core is attached to the specifi ed
cable only at one end, connect to the projector the end that the ferrite core is
attached at.
►Be careful not to set a connector into a wrong port or with a wrong way.
►Be careful not to damage the cables. Route the cables not to be stepped on
and pinched out.
NOTICE
►Do not turn your device on prior to the projector, except for the
cases directed by the manuals of devices.
(continued on next page)
►Use only the accessories specifi ed or recommended by
►Some connecting cable may have to have a specifi c length,
Setting up
77 ).
11