Dryer Description; To Open The Door; The Features; Control Panel - Hotpoint TCHL 73 Instruction Booklet

Dryer Description

To open the door

Press and release the front
panel in position shown
Condenser Unit
(cover open)

Control panel

Choosing a programme

1. Plug the dryer into the electrical socket.
2. Sort your laundry according to fabric type (see
Laundry).
3. Open the door and make sure the filter is clean
and in place and the water container is empty
and in place (see Maintenance).
4. Load the machine and make sure items are not in
the way of the door seal. Close the door.
5. If none of the lights are on: Press the ON/OFF
button .
6. Choose a programme by checking the Programmes
Guide (see Programmes) as well as the indications
for each type of fabric (see Laundry).
- Select a programme by rotating the
PROGRAMMES knob.
7. Set a delay time and other options if necessary.
8. The START/PAUSE light is flashing green:
- press the START/PAUSE
green light stops flashing.
During the drying programme, you can check on
your laundry and take out items that are dry
while others continue drying. When you close

The features

PROGRAMMES
Knob
Indicator
ON/OFF
Buttons & Lights
Button
button to begin. The
Water container
Condenser cover
Condenser cover handle
(Pull to open)
Clean Filter
Empty Water
Light
OPTION START/PAUSE
Button & Light
the door again, press the START/PAUSE button in
order to resume drying.
(When the door is opened the START/PAUSE light
will flash Amber, after the door is closed and the
START/PAUSE button pressed, the START/PAUSE
light will stop flashing and show green.)
Note: During the Post Care phase this light
flashes Amber.
9. At the end of the drying cycle the End light comes
on and either :
- The buzzer will beep 3 times to let you know
that your programme is complete.
or - If you have selected the Crease Care option
and you do not take the items out immediately,
the items will tumble occasionally for 10
hours or until you open the door, the buzzer
will then beep 3 times to confirm the
programme is completed.
10. Open the door, take the laundry out, clean the filter
and replace it. Empty the water container and
replace it (see Maintenance).
11. Unplug the dryer.
Rating plate
Model &
Serial
numbers
Air intake
grille
Filter
Clean
Light
Condenser
Light
Progress or Delay
Lights
7
GB