Interlocks And Relays - McCulloch MOWCART 66 Manual

SERVICE AND ADJUSTMENTS
1. Lift seat for bolt access.
2. Disconnect BLACK battery cable then RED battery
cable.
3. Remove battery bracket bolt.
4. Install new battery with terminals facing to the right, and
away from seat as shown.
5. Reinstall battery bracket and bolt.
6. First connect RED battery cable to positive (+) battery
terminal.
7. Connect BLACK grounding cable to negative (-) battery
terminal.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your riding mower to
run poorly, stop running, or prevent it from starting.
• Check wiring. Make sure all wiring and connectors are
secure.
TO REPLACE FUSE
Replace with 4 amp. or 5 amp. automotive type plug-in
fuse. The fuse holder is located under the fender.
ENGINE
Your engine speed has been factory set. Do not attempt to
increase engine speed or it may result in personal injury. If
you believe that the engine is running too fast or too slow,
take your riding mower to a qualified service center for
repair and/or adjustment.
Your carburetor is not adjustable. If your engine does not
operate properly due to suspected carburetor problems,
take your riding mower to a qualified service center for
repair and/or adjustment.
IMPORTANT: Never tamper with the engine governor,
which is factory set for proper engine speed. Overspeeding
the engine above the factory high speed setting can be
dangerous. If you think the engine-governed high speed
needs adjusting, contact a qualified service center, which has
proper equipment and experience to make any necessary
adjustments.
Fender
Battery
Battery
Bracket
20