Battery Replacement; Ac Power Adaptor - AC Tool Supply SC600 User Manual

Electronic counting scale/balance
Table of Contents

Advertisement

RS‐232 PC Interface 
The SC600 can stream data to a PC via the rear 3.5mm RS232  Output jack,  the optional 407001‐
USB  kit  (RS232  to  USB  cable  and  driver  CD)  along  with  the  407001  software  (available  free  at 
www.extech.com) are required.  
Battery Replacement 
 When the low battery icon appears on the LCD (LO), the batteries must be replaced. 
 The battery compartment is located on the bottom of the SC600. 
 Open the battery compartment using the battery compartment latches. 
 Replace the batteries observing correct polarity and replace the compartment carefully.
Never dispose of used batteries or rechargeable batteries in household waste. 
As  consumers,  users  are  legally  required  to  take  used  batteries  to  appropriate 
collection  sites,  the  retail  store  where  the  batteries  were  purchased,  or  wherever 
batteries are sold. 
Disposal: Do not dispose of this instrument in household waste. The user is obligated to take end‐
of‐life  devices  to  a  designated  collection  point  for  the  disposal  of  electrical  and  electronic 
equipment.  
AC Power Adaptor 
The AC adaptor can be used to power the SC600 from a 110/220/240 VAC power source. The 
adaptor capacity is 300mA. The AC adaptor plugs into the SC600 via the jack at the rear of the 
instrument. 
actoolsupply.com
8      
actoolsupply.com
  SC600‐EU‐EN v1.1   1/14 

Advertisement

Table of Contents
loading

Table of Contents