Display Unit Setup - AcuRite 01528 Instruction Manual

Display Unit Setup

AcuRite recommends high quality alkaline batteries for the best product performance.
Heavy duty or rechargeable batteries are not recommended.
1
Set the A-B-C Switch
The A-B-C switch is located inside
the battery compartment. It can
be set to A, B or C. However,
you must select the same letter
choices for both the sensor and
the display unit in order for the
units to synchronize.
1
A B C
IMPORTANT: Batteries are a backup power source to preserve records in the event of
a power outage. Power adapter is the recommended primary power source to enjoy
the full functionality of this product.
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be
used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used
batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire,
as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge
non-rechargeable batteries. DO NOT short-circuit the supply terminals.
2 Plug Power Adapter into
Electrical Outlet
3
Install or Replace Batteries
(optional)
Insert 6 x AA alkaline batteries into the
battery compartment, as shown. Follow
the polarity (+/-) diagram in the battery
compartment.
3
Install Backup
Batteries
6 AA Batteries
8
2
Plug in Power
Adapter