Setup; 5-In-1 Sensor Setup - AcuRite 01528 Instruction Manual

SETUP

5-in-1 Sensor Setup

1
Set the A-B-C Switch
Locate the A-B-C switch inside the
battery compartment. Set the A-B-C
switch to A, B or C. You must select the
same letter choices for both the sensor
and the display unit in order for the
units to synchronize.
Install or Replace Batteries
2
Batteries MUST be installed for
this product to operate. AcuRite
recommends high quality alkaline
or lithium batteries for the best
product performance. Heavy duty
or rechargeable batteries are not
recommended.
A B C
1
A-B-C Switch
Set to match
display unit
2
Install Batteries
4 AA Batteries
The 5-in-1 sensor requires lithium
batteries in low temperature conditions.
Cold temperatures can cause alkaline
batteries to function improperly. Use
lithium batteries in the 5-in-1 sensor for
temperatures below -4ºF / -20ºC.
1. Slide off the battery
compartment cover.
2. Insert 4 x AA batteries into the
battery compartment, as
shown. Follow the polarity
(+/-) diagram in the battery
compartment.
3. Replace the battery cover.
3
Remove Rain Gauge Stabilizer
Locate and remove the rain gauge
stabilizer (plastic tab) taped into the
bottom of the sensor. The rain gauge
will not function until this is removed.
3
Rain Gauge Stabilizer
Remove and discard
7