4. When the washer/dryer is level, use a ⁹⁄₁₆" open-end wrench
to securely tighten all four locknuts against the pedestal. The
locknuts must be tightened to prevent vibration.
5. Align front panel with pedestal and snap in place.
For washer/dryer models that are 38" (96.5 cm) high, the wide
edge should be placed on top.
For washer/dryer models that are 36" (91.4 cm) high, the wide
edge should be placed on bottom.
38" (96.5 cm)
36" (91.4 cm)
Full One-Year Warranty on Mechanical parts.
For one year from the date of purchase, supplier will repair or
replace any of its mechanical parts if defective in material or
workmanship. This Pedestal must be installed with the listed
washer or dryer and operated according to the instructions
provided in the washer or dryer Owner's Manual or Use and Care
If the Pedestal is subject to other than private family use and or
used with any other product than those listed in the Installation
Instructions, the warranty is null and void.
Warranty service is available by contacting the retailer where the
Pedestal was purchased. If retailer is not available, please refer to
the Owner's Manual or Use and Care Guide that came with the
washer or dryer that is installed with the Pedestal and contact
the service department listed there.
This warranty applies only while the Pedestal is in use in the
United States or Canada*. This warranty gives you specific legal
rights and you may also have other rights which vary from state
to state or province to province.
*Warranty terms may vary in Canada.
In the space below, record your model number information and
purchase date. See the serial plate located on the side frame of
the Pedestal, for model number information.
Have this information available to help you quickly obtain
assistance or service.
Save these instructions and your sales receipt for future