Table of Contents
Advertisement
LIMIT KEY
STEP KEY
ENTERKEY
SEARCH KEY
HOLD KEY
AUTO KEY
This key has two functions in Search Mode:
(a) to step down a frequency; and (b) to set
the search band limits. To manually step
down, press and hold [LMT].
Press and hold
for more than one second to rapidly move
down the frequencies.
To set the lower and upper limits of the
search band, first enter the number for the
lower limit and press [LMT].
Then enter the
number for the upper limit and press [LMT].
Use [STP] to change the step increment
when accessing frequencies.
Press [STP] to
change thE;factory preset auto step to 5 kHz,
I
12.5 kHz, 25 kHz, or 50 kHz, or press [.]
twice to reset back to auto steps. (The
selected step setting appears on the display.)
(Within the numeric keypad)
Press [E] to
store a displayed fre_quency into any
displayed channel.
Note: If you try to store
the same frequency
into another channel,
the
display will show the original channel
for that
frequency. To store the same frequency into
the selected
channel,
press [E] again.
Press [SRC] to start searching for active
frequencies within preset ranges of any
band. Normally, the search continues from
the frequency where it left off in the previous
search. The scanner will automatically start
searching upward from the lowest frequency
of its band. ("SRCH" appears on the display
in Search Mode.)
During Search, you can press [LMT] to hold
the displayed frequency, and press [LMT]
again to manually step down a frequency, or
press [HLDl to manually step u~a
frequency.
~ress and hold [LMTj or [HLD]
to rapidly step through the frequencies.
Press [HLD
~
in Search Mode to stop
searching.
'HOLD"appears on the display.)
Press [HLD
again to step up one channel.
Press and hold[HLD]
for more than 1
second to rapidly move through the
frequencies.
In Hold Mode, press [LMT] to
STEP DOWN to the next lower fre9..uency.
To resume the search, press [SRCj.
Use [AUTO] to automatically store active
frequencies Into open (empty) channels of
specified banks. To use Auto Store, first set
the upper and lower limits of the band to be
searched.
In Search Mode, press [AUTO] to
activate the Auto Store feature.
Press the
numeric key(s) for the bank(s) to store the
frequencies.
("AUTd' appears on the display
11
Advertisement
Table of Contents
