ECS P67H2-A4 Manual page 38

32
Smart Fan Function
Scroll to this item and press <Enter> to view the following screen:
Main Advanced
CPU SMART Fan Control
SMART Fan Mode
SMART Fan start PWM value
SMART Fan start PWM TEMP(-)
Delta T
SMART Fan Slope PWM value
CPU Fan Full Speed Offset (-)
System SMART Fan Control
SMART Fan Mode
SMART Fan start PWM value
SMART Fan start PWM TEMP(-)
Delta T
SMART Fan Slope PWM value
System Fan Full Speed Offset (-)
Power SMART Fan Control
SMART Fan Mode
SMART Fan start PWM value
SMART Fan start PWM TEMP(-)
Delta T
SMART Fan Slope PWM value
CPU/System/Power SMART FAN Control (Enabled)
This item allows you to enable or disable the control of the CPU/system/power fan
speed by chang-ing the fan voltage.
SMART Fan Mode (Normal)
This item allows you to select the fan mode (Normal, Quiet, Silent, or Manual) for a
better operation environment. If you choose Normal mode, the fan speed will be auto
adjusted depending on the CPU temperature. If you choose Quite mode, the fan speed
will be auto minimized for quiet environment. If you choose Silent mode, the fan
speed will be auto restricted to make system more quietly. If you choose Manual
mode, the fan speed will be adjust depending on users' parameters.
SMART Fan start PWM value (56)
This item is used to set the start PWM value of the smart fan.
SMART Fan start TEMP(-) (30)
This item is used to set the start temperature of the smart fan.
DeltaT (+3)
This item specifies the range that controls CPU temperature and keeps it from going
so high or so low when smart fan works.
SMART Fan Slope PWM value (10 PWM value/unite)
This item is used to set the Slope Select PWM of the smart fan.
Aptio Setup Utility - Copyright (C) 2010 American Megatrends, Inc.
Chipset M.I.B III
Version 2.02.1205. Copyright (C) 2010, American Megatrends, Inc.
Using BIOS
Boot Security Save & Exit
[Enabled]
[Normal]
56
30
+3
10 PWM value / unite
10
[Enabled]
[Normal]
56
30
+3
10 PWM value / unite
10
[Enabled]
[Normal]
56
30
+3
10 PWM value / unite
:Select Screen
:Select Item
Enter : Select
+/- : Value
F1:General Help
F2:Previous Value
F3:Optimized Defaults
F4:Save & Exit
ESC:Exit