Table of Contents
Advertisement
WARNING Never use water for cleaning your product,
use only a dry cloth. Do not clean with chemicals or
solvents, some can destroy critical plastic parts.
After Using Your Gardenvac (Q1, 2, 3 & 4)
1. Switch off and disconnect from the mains electricity sup-
ply before cleaning your product.
2. Always empty the debris bag.
3. Take extra care to clean around the cutting head and the
collection chute.(Q1)
• Take care when cleaning around the cutting line area
- sharp edges can cause injury.
4. Inspect the cutting line and replace if worn or damaged
5. Using a soft brush remove debris from all air inlets. (Q2)
6. Remove dirt and debris from debris fin.with a suitable
tool. (Q3)
7. Wipe over your product with a soft dry cloth. (Q4)
Replacing the Cutting Line (Q5 & 6)
• Switch off and disconnect from the mains electricity
supply before replacing the cutting line
• Handle the cutting line with care - sharp edges can
cause injury.
1. Remove debris bag from product. See Page 4.
2. Remove cutting line (Q5) and discard safely.
3. If the cutting line becomes broken during use - use a suit-
able tool to lever the line out of location. (Q6).
4. Place the cutting line into the slot in the cutting head.
Ensure the cutting line is correctly located. See Page 3.
5. Re-fit debris bag to product. See Page 3.
Storing Your Gardenvac
Always store the product in a dry place ensuring the cable is
not likely to be damaged on sharp edges etc.
Fails To Operate
1. Is the power turned on?
2. Is the fully assembled debris bag correctly fitted to the product?
3. Check the fuse in the plug, if blown replace.
4. Fuse continues to blow?
Immediately disconnect from the mains electricity supply
and consult your local Service Centre/Dealer/Distributor
Poor Blowing
1. The air inlets are blocked, clean all air inlets.
2. Mode indicator not in the right position?
3. If poor blowing persists?
Immediately disconnect from the mains electricity supply
and consult your local Service Centre/Dealer/Distributor
Poor Vacuum/Jet Vacuum
1. The air inlets are blocked, clean all air inlets.
2. Mode indicator not in the right position?
3. If poor vacuuming persists?
Immediately disconnect from the mains electricity supply
and consult your local Service Centre/Dealer/Distributor
1. We strongly recommend that your product is serviced at
least every twelve months, more often in a professional
application.
2. Always use genuine Spare Parts.
3. Prepacked spares are available from most Electrolux
Outdoor Products stockists.
4. Your product is uniquely identified by a silver and black
product rating label
5. If you have a problem with your machine contact your
local Approved Service Centre ensuring you have full
details of your product as described on the product rating
label.
Electrolux Outdoor Products are manufactured under an Environmental Management System (ISO 14001) using, where
practical, components manufactured in the most environmentally responsible manner, according to company procedures,
and with the potential for recycling at the end of the products' life.
•
Packaging is recyclable and plastic components have been labelled (where practical) for categorised recycling.
•
Awareness of the environment must be considered when disposing of 'end-of-life' product.
•
If necessary, contact your local authority for disposal information.
Caring for your Gardenvac
Fault Finding Hints
Excessive Vibration
1. The cutting line is damaged - replace with new cutting line.
2. Ensure the fully assembled debris bag is correctly fitted
3. If excessive vibration persists?
Poor Shredding
1. The cutting line is damaged - replace with new cutting line.
2. TO PROLONG CUTTING LINE LIFE
3. If poor shredding persists?
Service Recommendations
6. Should it be necessary for work to be carried out by your
A network of specialist dealers can be found in your local
Yellow Pages. To obtain service on your product simply
telephone or visit your local Service Centre. Should you
require service under the terms of our guarantee the
Service Centre will require proof of purchase.
All of the centres listed stock genuine Spare Parts.
NOTE: Our Service Repairers act on their own behalf
and are not empowered to commit or legally bind
Electrolux Outdoor Products in any manner whatsoever.
Environmental Information
Q1
Q3
Q5
to the product.
Immediately disconnect from the mains electricity supply
and consult your local Service Centre/Dealer/Distributor
The Gardenvac has been designed to shred leaves. If
collecting large amounts of any other debris - remove the
cutting line.
Immediately disconnect from the mains electricity supply
and consult your local Service Centre/Dealer/Distributor
Service Centre, it is important to take your complete
machine including cable and any extension cables used.
6
Q2
Q4
Q5
Advertisement
Table of Contents
