Installing The Universal 2 Pin “Reverse Power” Hard Wire Kit - Audiovox Obstacle Sensing System ASH300 Owners & Installation Manual

INSTALLING THE UNIVERSAL 2 PIN "REVERSE POWER" HARD WIRE KIT
This adapter is designed for use with vehicles without a 7-way factory trailer connection. The tools required for this
installation are:
- 12Volt Meter for testing power (use of a Test Light is NOT recommended)
- Pliers
- Wire Crimpers
- Electrical Tape
WARNING: Do not plug 2 pin harness into factory (OEM) or aftermarket 4 pin connectors, and if used may cause
damage to the unit and void any implied warranty.
This adapter kit will use the +12V power supply normally located at the reverse bulb and ground.
1.) Connect the hard wire 2-pin connector to the sensing unit 2-pin connector. Route the harness from the
hitch receiver location into the vehicle and up to the reverse bulb location.
2.) Set the parking brake, Locate the wire that measures +12 volts when the vehicle ignition is turned on to
the run position (do not start the vehicle) and the gear selector is placed into the reverse position. Move
the gear selector back into the park position and the selected wire will measure 0 volts.
3.) Connect the orange wire from the inline fuse to the selected wire.
4.) Connect the red wire from the 2-pin harness to the opposite end of the orange wire of the inline fuse using
the red butt connector supplied.
5) Connect the black wire from the 2-pin harness to the vehicle's ground wire.
-11-