Table of Contents
Advertisement
Hitch Receiver Conversion and Hardwire Kit
Most vehicles come equipped with a 1¼" or a 2" trailer hitch receiver. Your system can be converted to fit the
vehicle's receiver by simply sliding the 2" sleeve (A), off the center of the 1¼" system shaft for use on 1¼" hitch
receivers. The hitch-lock kit (C,D,E) comes with 2 sizes of pin shafts (C and D) to accommodate the 2" and 1¼"
hitch pin holes. Included are rubber hitch lock spacers (G) designed to take up slack between the hitch receiver
pin holes and hitch-lock. The foam stabilizers (F) are included to take up slack between unit and vehicle's hitch
receiver.
If your vehicle does not have a 7-way trailer plug, your system includes a 2-pin reverse power harness kit (H). For
instructions, please refer to install card included with hardwire install kit.
-10-
Advertisement
Table of Contents
