Voice Recognition - Chrysler 2010 Sebring User Manual

Receiving A Call – Accept (And End)
• When an incoming call rings / is announced on uconnect™, press the Phone
button .
• To end a call, press the Phone button
Mute (Or Unmute) Microphone During Call
• During a call, press the Voice button
• (After the BEEP), say "mute on" (or "mute off ").
Transfer Ongoing Call Between Handset And Vehicle
• During a call, press the Voice button
• (After the BEEP), say "transfer call".
Changing The Volume
• Start a dialogue by pressing the Phone button
a normal call.
• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable
level while the uconnect™ system is speaking. Please note the volume setting for
uconnect™ is different than the audio system.
NOTE: To access the tutorial, press the uconnect™ hard-key. After the BEEP, say
"tutorial". Press any hard-key or touch the display to cancel the tutorial.

VOICE RECOGNITION

• The Voice Recognition (VR) system allows you to control your AM, FM radio,
satellite radio, disc player, and a memo recorder. When you press the VR
button , you will hear a beep. The beep is your signal to give a command. If you
do not say a command within a few seconds, the system will present you with a list
of options. If you ever wish to interrupt the system while it lists options, press the
VR button , listen for the BEEP, and say your command.
• Please refer to uconnect™ tunes in the uconnect™ User's Manual on the DVD for
further details.
Changing The Volume
• Start a dialogue by pressing the VR button
"tutorial").
• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable
level while the Voice Recognition system is speaking. Please note the volume
setting for Voice Recognition is different than the audio system.
ELECTRONICS
.
.
.
, then adjust the volume during
, then say a command (e.g.,
33