Clone Port Option - EEG EN 530 Instruction Manual

Appendix C: Clone Port Option
Down
Down
Toggle Clone Port
Clone Port is a factory option that configures P2 to transmit duplications of all
control commands and data that are received through the dial up modem. This
data port can then be connected to an input port on a second Encoder. This allows
two or more Encoders performing the same task to be controlled using only one
dial-up input.
To use Clone Port on an enabled Encoder, create an RJ11 cable as shown in the
diagram below. For RS422 configuration, make sure to respect the reverse tab
position shown. Use this cable to connect P2 on the Clone port enabled Encoder
to any of the general purpose serial input ports on the second Encoder. Be sure
that the baud rates of the two ports match.
RS232 Configuration
BLUE
YELLOW
Tab
GREEN
RED
BLACK
WHITE
RS422 Configuration
BLUE
Tab
GREEN
RED
WHITE
<CTRL+A>D ON/OFF <ENTER>
Toggles P2 On or Off as Clone port on a clone port enabled Encoder. This
command can only be entered through P3. When P2 is toggled Off for Clone
port, it will function normally as a general purpose serial input port. If this
command is entered without the On/Off parameter, it will return the current P2
setting.
On a Clone port enabled Encoder, Clone port will be automatically toggled On
each time the unit is power cycled. Note that P2 will not respond to input
commands when Clone port is toggled on.
©2000-2007 EEG Enterprises, Inc.
EN530 HDTV Smart Encoder IV
BLUE
YELLOW
Tab
GREEN
RED
Down
BLACK
WHITE
GREEN
Tab
BLUE
WHITE
Up
RED
33