Zenith P50W26 series Service Manual page 17

16. PIP sound select (Command:u)
To select main or sub (inset) sound for PIP.
You can also select sound select in PIP on the
special menu.
Transmission
[u][ ][Set ID][ ][Data][Cr]
Data 0 : Main picture sound
1 : Sub picture sound
Acknowledgement
[Set ID][:][OK][x][Data][x]
Data 0 : Main picture sound
1 : Sub picture sound
* COMPONENT source only works in 480i input signal.
17. PIP position (Command:x)
To select sub picture position for PIP.
You can also adjust the sub picture position using the
position button on the remote control or in PIP on the
Special menu.
Transmission
[x][ ][Set ID][ ][Data][Cr]
Data 0 : Right down on screen
1 : Left down on screen
2 : Left up on screen
3 : Right up on screen
Acknowledgement
[Set ID][:][OK][x][Data][x]
Data 0 : Right down on screen
1 : Left down on screen
2 : Left up on screen
3 : Right up on screen
PV154 - 923-03499
SERVICING
18. Change into Remote control
adjustment mode (Command:j)
To control the Monitor with the remote control while
the cable is still connected.
Transmission
[j][ ][Set ID][ ][Data][Cr]
Data 1 : Remote control adjustment mode
Acknowledgement
[Set ID][:][OK][x][Data][x]
Data 0 : PC adjustment mode
1 : Remote control adjustment mode
* If external equipment commands the Monitor to
"change into remote control adjustment mode", the
Monitor can only be adjusted by the remote control.
To revert the Monitor control to external control device
adjustment, turn the Monitor off and then on again.
17
P50W26 - SERVICING