Maytag Agility User Manual page 12

41
42
43
D
44
E
F
45
12
Routine care for your Deep Cleaner
Clean the nozzle
A
Unplug deep cleaner from electrical source.
Remove solution and recovery tanks to prevent possible leaks.
Lift up on top of nozzle (A) and slide off cleaner (Fig. 41).
Wipe debris off nozzle and front of cleaner with a damp cloth.
B
Tilt cleaner back, raising front of cleaner off floor. Slide nozzle
(B) up from bottom of cleaner (Fig. 42).
Press on upper portion of nozzle to snap in place.
Clean the brushes
Unplug deep cleaner from electrical source.
Remove solution and recovery tanks to prevent possible leaks.
Tilt cleaner back so handle rests on the floor.
Pull brush assembly firmly to remove (Fig. 43).
Rinse brushes under running water.
Align posts (C) on brush assembly with slots (D) in cleaner
(Fig. 44).
Turn brushes slightly to align square post (E) with square hole
(F) in cleaner (Fig. 44).
C
Press brush assembly firmly and snap in place.
Clean the brush filter
Unplug deep cleaner from electrical source.
Remove solution and recovery tanks to prevent possible
leaks.
Tilt cleaner back so handle rests on the floor.
G
Squeeze filter frame (G) and pull it out until it stops (Fig. 45).
Wipe debris off filter.
Slide filter back into place.