Table of Contents
Advertisement
OPERATING
THE CONTROLS
Your new rcfrigcrator has two controls: one for the refrigerator compartment
and one t_r the freezer compartment.
These controls are located at the top, rear of the refrigerator compartment.
FREEZER
REFRIGERATOR
I
I
[) INITIAL SETTING
64NITIALSE_ING
G COLDESTSE_ING
H_;OLDEST SETTING
Initial Setting of Controls
ADJUSTING
THE
Freezer
Control:
This cuntrol has settings fi'om A
(warmest) to G (coldest) Initially set this control to D.
I NTE
RI O R
Sure-Loci(
Shelves
NOTE:
Tile coldest freezer setting (G) is recom-
mended for short term use only.
The refrigerator shelves are adjustable, allowing you to
arrange the shelxing to fit your famil>'s tbod storage
Refrigerator
Control;
This control has settings from
needs.
Never
attempt
to adjust
a shelf
that
is
1 (warmest) to I1 (coldest). Initially
set this control
luaded with food.
to 6. The refrigerator luay run for several hours when
you first start it. This is normal.
To remove
the refrigerator
shelf:
Let the refrigerator
run at least
8 to 12 hours
1. Grasp the shelf at the front with one hand and pnsh
before
adding
food. A day or so after adding tbod,
up under the shelf back with the other hand.
you may decide one or both compartments
should be
9. Lili the shelf straight ont.
colder or warmer. If so, adjnst the control(s) as instruct-
ed below.
__
Adjusting
the
Temperature
Controls
; ;
Except when starting the refrigerator, do not change
either
control
more than one number
or letter at
a time. Allow 24 hours for the temperatnre
to stabilize
•
o.
•
before resetting. Chang ne, ether co atrol _ fll have some
effect on the temperature
of the other compartment.
Freezer
too warm--Tnrn
tim freezer control to the
succeeding letter. For example, turn the control from
D to E.
To replace
the refrigerator
shelf:
Freezer
too cold--Turn
the freezer control to the
preceding letter. For example, tnrn the control from
1. Keeping tile shelf horizontal, guide the three support
D to C.
tabs into the slots in the shelf supports at the rear of
the cabinet.
Refrigerator
too warul
Turn the refrigerator con-
trol to the next higher number. For example, tunl the
'2. Lower the shelf until the tabs lock into position.
control fi'om 6 to 7.
Make sure the shelf is securely locked into position
Refrigerator
too cold--Turn
the refrigerator con-
before loading it with fixed.
trol to the next lower number. For example turn the
control fi'om 6 to 5.
Easy-Glide
Shelves
Grasp tile: front edge of the shelf and pull fonvard. Push
Warm Cabinet
Surfaces
i,_ shelf to return to the original position•
Some portions of the cabinet may be warm to the
touch. This is a normal function
of the refrigerator
which helps prevent moisture fi'om condensing on the
cabinet. This condition will be inure noticeable when
you first start your refi'igerator, during hot weather and
after excessive or lengthy door ot)enings.
PAGE 3
Hide quick links:
Advertisement
Table of Contents
