Table of Contents
Advertisement
INSTALLATION
t:lemo_e and discard the cantilever shelf packing clips
if the t]oor is not level and it is neeessary to raise the
located just above eaeh shelf where it books onto the
rear of thc cabinet, we suggest, rollin(r the rear wheels
fi'ame. To remove the plastic clips, wiggle the clips
onto apiece ofpI)weod
or other shim materiah
sideways and pull straight ont.
4. To replace, center the clips in the cut-out areas and
Locating Your Refrigerator
pnsh in until the hase grille snaps into place.
1. Allow a free l]uw of'air through the front base grille.
Connecting
the
Appliance
9. "llmr model should not be installed where the room
tel'llperature will go below 55° E, because it will not
WARNING,:
This app]ianee is designed to operate
run
frequent b,
enough
to
maintain
proper
on a normal I15 volt, 15 amp, 60 c)cle line. There
temperature
in the freezer,
should be a separate, grounded circuit serving this
:3. For ease of installation, ,v°u should leave a space of"
appliance only. Do not use an extension cord•
about 1/2 inch between the refi-igcrator and adjacent
This appliance
is equipped
with a three-pronged
walls or cahinets. If"the refrigerator is placed _@h the
gronnding
plug for yoJtr protection
against pnssihle
hinge side against a wall, you may want to leave
electrical shock hazards.
It nmst he plugged into a
additional space so the door can be opened wider,
grounding receptacle. Where a standard two-prong wail
(Refer to the installation
instructions
for more
detail.)
receptacle
is
encountered,
it
is the
personal
responsihilit)
and obligation of the cnstomer to have it
Important
Leveling
Information
replaced
with a properly
grounded
three-prong
wall
Your refrigerator is equipped x_4thfront and back rollers
receptacle.
Do not under an_ circumstances,
cut or
remove the third (grotmd) prong t)com the power cord.
so it can be moved myra' front the wall fur cleaning. The
front rollers are a@tstahle and shonld he positioned so
Do no_ rise an adapter plug.
the refrigerator sits firmh' on the flonr and is level.
To adjust
the front
rollers:
/_
l. Hemnve the hase grille by grasping the ends, Iif}and
)ul] out.
®
: [
Energy Saving lips
1. Locate the refrigerator away from heat producing
2. To ]exel the ret_'igerator, use a screwdriver and turn
appliances
sueh as the range or dishwasher, heat
roller adjusting screws elocka_dse to lower the cahinet
vents and direct sunlight.
or countereloeka_dse to raise the cabinet.
2. Level the refrigerator
and do not Nock xentilation
around the front grille.
3. Keep the freezer full to near capacity so less cold air
will escape during door openings. When less than
two-thirds full, place milk cartons half fhll of water in
the freezer.
4. Let hot dishes cool slightly before putting into the
refrigerator or freezer.
TURN
CLOCKWISE
TO
LOWER
CABINET
CORNER.
5.
Cover
liqnids.
TURN
COUNTER-
CLOCKWISE
TO RAISE
6.
Wipc
moisture
fron-t
the ontsidc
of
containcrs
he}ore
CAmNET C ORNER.
placing them into the refrigerator.
3. It is not necessary tn lock the refrigerator in place.
7. Avoid opening the doors too often.
However, if that is desirable, turn one or both of the
locking tSet elockavise. The) are located near the
front wheels.
PAGE 1
Hide quick links:
Advertisement
Table of Contents
