Maytag RSW2200 Use & Care Manual page 12

CARE AND CLEANING
Refer to the chart on page 13 when cleaning the reffig- To replace the upper refrigerator bulbs:
erator. 1. Unplug the refrigerator.
2. Remove the light shield by grasping the bottom of
CAUTION: Disconnect the power cord before the shield at each end and pull fb]ward to remove.
cleaning. Also, do not touch refrigerated
surfaces with wet or damp hands. Damp objects 3. Lift up and remove the shield.
stick to the cold metal surfaces. Before cleaning the 4. Unscrew the bulb and replace with a 40 watt appli-
freezer, allow it to warm up. Allow glass shelves to anee bulb.
warm up before immersing in warm water. 5. Replace the light shield by hooking the top of the
shield over the plastic pins. Secure the bottom of the
shield by pushing in on middle edges of the shield at
Cleaning Under the Refrigerator
both ends.
Your refrigerator can be rolled out }br cleaning the floor To replace the lower refrigerator bulb:
underneath. Simply unlock the front roller locks (see
page 1). Pull the refrigerator straight out from the walh 1. Unplug the ref3"igerator.
'2. Remove the Meat/Cheese drawer
Cleaning the Defrost Pan
3. Using twu hands, spread the top and bottom of tile
The defrost water drains into a shallow pan beneath the light shield vertically away from each other and pull
cabinet and evaporates. This pan should be cleaned to tile front to remove.
periodically with warm sudsy water. 4. Unscrew the bulb and replace with a 40 watt show-
To remove the defrost pan: case bulb.
I. Remove the base grille (see page 1). 5. Using two bands, spread the top and bottom of the
light shield and push it into plaee, engaging the tabs
2. Lit} the pan up and pull out. into tile slots.
To replace the defrost pan: 6. Replace the Meat/Cbeese drawer.
1. Position the side flanges to fit over the slide rails and
Freezer
press down on the center of tile pan to snap in place. The t_ceezer light is located in tile upper portion of the
2. Replace the base grille, freezer compartment.
', To replace the freezer bulb:
1. Unplug tile refrigerator.
2. Remove the ice bin (see page 9) and the freezer shelf
"'"', (see page 5).
3. Unhook tile tabs on the top of the light shield by
pressing in with )xmr thumb on the center top of the
light shield. Pivot the shield down.
4. Unscrew the bulb when cool and replace it with a
standard 40 watt appliance bulb.
Replacing the Interior Lights
5. Pivot tile shield up into place, snapping the tabs into
the slots. Replace the freezer shelf and ice bin.
1
CAUTION: Disconnect
the
power cord before [
Ice and Water Dispenser
replacing light bulb(s)• Wear glo_es _s px0tection |
• . ,
against possible broken g_asg / To replace the dispenser bulb:
1. Unplug the refrigerator.
Refrigerator
2. Reach up behind the decorative panel on the right
Two upper li_41tsare located behind, the full width li_ht_, side, unscrew tile bulb and replace it with a 7 watt
shield at the top back of the refrigerator compartment, appliance bulb.
A lower rel)igeratur light is located behind the
Meat/Cheese drawer on select models.
PAGE 11