Hitachi G 18SCY Handling Instructions Manual
Hide thumbs
Also See for G 18SCY:
- Handling instructions manual (72 pages) ,
- Technical data and service manual (55 pages) ,
- Handling instructionss (53 pages)
Table of Contents
Advertisement
Quick Links
Disc Grinder
Model
Handling instructions
NOTE:
Before using this Electric Power Tool, carefully read through these
HANDLING INSTRUCTIONS to ensure efficient, safe operation. It
is recommended that these INSTRUCTIONS be kept readily
available as an important reference when using this power tool.
G 18SCY
G 18UBY
G 23SEY
G 18SEY
•
G 23SCY
•
G 23UBY
•
G23SEY
Advertisement
Table of Contents
Related Manuals for Hitachi G 18SCY
Summary of Contents for Hitachi G 18SCY
- Page 1 Disc Grinder Model G 18SCY G 18SEY • G 18UBY G 23SCY • G 23SEY G 23UBY • Handling instructions G23SEY NOTE: Before using this Electric Power Tool, carefully read through these HANDLING INSTRUCTIONS to ensure efficient, safe operation. It is recommended that these INSTRUCTIONS be kept readily available as an important reference when using this power tool.
- Page 2 d) Remove any adjusting key or wrench before turning GENERAL SAFETY RULES the power tool on. A wrench or a key left attached to a rotating part of WARNING! the power tool may result in personal injury. Read all instructions e) Do not overreach.
-
Page 3: Precautions On Using Disc Grinder
5. Inspect the depressed center wheel before use, do PRECAUTIONS ON USING DISC GRINDER not use chipped, cracked or otherwise defective products. 1. Never operate these power tools without Wheel 6. Always hold the body handle and side handle of the Guards. -
Page 4: Practical Grinder Application
Lever Set piece Screw 15 – 30° Fig. 2 3. To prevent a new depressed center wheel from Locating pin digging into the workpiece, initial grinding should be performed by drawing the grinder across the workpiece toward the operator (Fig. 2 direction B). Once the leading edge of the depressed center wheel Fig. -
Page 5: Maintenance And Inspection
For your continued safety and electrical shock protection, carbon brush inspection and replacement NOTE: on this tool should ONLY be performed by a Hitachi Due to HITACHI’s continuing program of research and Authorized Service Center. development, the specifications herein are subject to... - Page 12 Hitachi Koki Co., Ltd. Code No. C99155212 Printed in Malaysia...